Smeg DF344BW Manual page 27

User instructions
END PROGRAM
At the end of the program the DISPLAY shows "end". By pressing one of
the program buttons the dishwasher is ready to start a new cycle.
INTERRUPTING A PROGRAM
In order to interrupt a running program it is necessary:

to press the START/PAUSE
led START/PAUSE remains lit on (confirmation beep). At this point,
it is possible to start the cycle again, otherwise:

TO CHANGE A PROGRAM
To change the running program it is necessary:

to interrupt the running program (see "I

select the new program;

to press again the START/PAUSE button
program.
STOPPING A PROGRAM
To cancel a program which is running:

Interrupt the program (see "

Press the START/PAUSE button
display will show "P0" and the dishwasher will immediately
switch to the end of the cycle and drain the tank (during this
process, the "START/PAUSE led will flash). When the drain
procedure ends, the end of cycle "End" message appears on
the display.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph "
S
TARTING THE PROGRAM
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program will
start about 60 seconds later.
for some seconds until when the
NTERRUPTING A PROGRAM
to make start the new
INTERRUPTING A PROGRAM
and hold it down; the
". The program will resume from the
");
")
27