Table of Contents
Advertisement
Correcting the date
1. Depress the SELECT button
Q
to make a
different category of digits on the LCD panel
that you want to change blink.
2. Depress the ADJUST button 0 to change
digits of the specified category you chose
with the SELECT button ©. Digits increase
by one each time you depress the ADJUST
button
0
.
Holding down the button will ad¬
vance digits continuously,
3. After the data has been adjusted, depress the
SELECT button
0
each time until blinking
stops.
• Depress the SELECT button © each time.
The bar mark ( — ) appears on the LCD
panel,
indicating
that
data
imprinting
choices are possible.
• The blinking " : '' allows precise fine-tuning
of the internal clock to the beginning of a
specified minute. To do so, depress the mode
button O
until "Day-Hour-Minute" digits
appear and then depress the SELECT button
0
to make the " : " blink. Then depress the
ADJUST button
0
in sync with a time sig-
nal.
• If you release the shutter while the blinking
data is being corrected, the data cannot be
imprinted.
Operational precautions
The data on the LCD panel O is imprinted on
each frame you expose.
• "Year-Month-Day" and "Day-Hour-Minute"
cannot be imprinted at the same time.
• As you release the shutter, the bar( —) mark
on the display blinks for a few seconds, indi¬
cating the data has been imprinted.
• If there is a white or yellow object in the cor¬
ner of the picture where the data is im¬
printed, the data may be difficult to read.
When composing your photographs, try to
avoid brightly-colored subjects in that cor¬
ner.
27
Advertisement
Table of Contents
