Table of Contents
Advertisement
M
Setting the signal and
current
Y ou can change the following settings:
S e t t i n g t h e s i g n a l a n d c u r r e n t
The spin speed that was used for
■
spinning in the washing machine;
used exclusively to more accurately
display the anticipated drying time,
the volume of the audible signal at
■
the end of the programme,
the volume of the audible button
■
signals,
the current rating for your dryer's
■
fuse (10 A or 13 A).
The values for the energy
Note:
label are determined using a circuit
breaker/fuse rating of 13 A. If the
circuit breaker/fuse rating is
changed to 10 A, the drying time
and energy consumption will be
higher. You can find details on this in
the consumption values table.
You will need to activate setting mode
before you can change these settings.
Activating setting mode
Switch the dryer on.
1.
Select the "Cottons" programme in
2.
position 1 and wait for five seconds.
Setting mode is now activated. The
symbols go out on the display panel
and the programme duration is
displayed.
Press and hold the Start button and,
1.
at the same time, turn the
programme selector clockwise to
position 2.
The spin speed is shown on the
2.
display.
Press the "Ready in" time button or
3.
the drying time button to change the
spin speed.
Setting the signal and current
Turn the programme selector
4.
clockwise to position 3.
The volume for the audible signal at
5.
the end of the programme is shown
on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Ready in" time button or
6.
the drying time button to change the
volume.
Turn the programme selector
7.
clockwise to position 4.
The volume for the audible button
8.
signal is shown on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Ready in" time button or
9.
the drying time button to change the
volume.
Turn the programme selector
10.
clockwise to position 5.
The current is shown on the display.
11.
LO = 10 A
HI = 13 A
Press the "Ready in" time button or
12.
the drying time button to change the
current.
Exiting setting mode
Turn the programme selector to the
"Off" position once you have set the
required spin speed, volume or fuse
current rating. The settings have now
been saved.
en
31
Advertisement
Table of Contents
