Gas Connection - Smeg PGF95HK Manual

Table of Contents

Advertisement

opens on bottom
opens on rear
Over empty kitchen unit or drawers
If there are other pieces of furniture (lateral
walls, drawers, etc.), dishwashers or fridges
under the hob, a double-layer wooden
base must be installed at least 10 mm from
the bottom of the hob to avoid any
accidental contact. It must only be possible
to remove the double-layer base using
suitable equipment.
Failure to install the double-layer
wooden base exposes the user to
possible accidental contact with
sharp or hot parts.
18
Installation

5.5 Gas connection

• After carrying out any operation, check
that the tightening torque of gas
connections is between 10 Nm and
15 Nm.
• If required, use a pressure regulator that
complies with current regulations.
• At the end of the installation, check for
any leaks with a soapy solution, never
with a flame.
• The hoses should not come into contact
with moving parts and should not be
crushed in any way.
General informations
Connection to the gas mains can be made
using a rigid copper pipe or a continuous
wall steel hose in compliance with the
provisions established by the applicable
standard.
For supplying types of gas are shown in "".
Use approved gas tubing bearing EMSD
approval marking (such as :
EMSD APPROVAL GTXXXX) for
connection to appliances, or other
appropriate methods accepted by EMSD.
Gas leak
Danger of explosion

Advertisement

Table of Contents
loading

Table of Contents