Casio 5682 Operation Manual page 36

Barometric Pressure
Measurement
Q1
Following a relative barometric
pressure reading, the watch's
second hand points to 9 o'clock.
The second hand will move to 9 o'clock if a
reading is outside the allowable barometric
pressure measurement range (260 hPa to
1,100 hPa (7.65 inHg to 32.45 inHg)). If [ERR]
appears on the display, there may be a
problem with the sensor.
Checking the Change in Barometric
l
Pressure between Two Readings
Q2
[ERR] appears during measurement.
There may be a problem with the sensor. Try
taking another measurement. If [ERR] keeps
appearing after multiple measurement
attempts, contact a CASIO service center or
your original retailer.
Temperature Measurement
Q1
[ERR] appears during measurement.
There may be a problem with the sensor. Try
taking another measurement. If [ERR] keeps
appearing after multiple measurement
attempts, contact a CASIO service center or
your original retailer.
World Time
Q1
The time for a World Time City is not
correct.
The summer time setting (standard time/
summer time) may be wrong.
Specifying a World Time City
l
Watch Operation Guide 5682
Alarm and Hourly Time
Signal
Q1
An alarm does not sound.
Is the watch's battery charged?
Keep the watch exposed to light until it
recharges sufficiently.
Charging
l
The crown is pulled out.
The alarm will not sound while the crown
is pulled out. Push the crown back in to its
normal position.
Other than the above.
The alarm's settings may not be
configured. Configure the alarm settings.
Configuring Alarm Settings
l
Q2
The hourly time signal does not
sound.
Is the watch's battery charged?
Keep the watch exposed to light until it
recharges sufficiently.
Charging
l
The crown is pulled out.
The hourly time signal will not sound while
the crown is pulled out. Push the crown
back in to its normal position.
Other than the above.
The hourly time signal may be disabled.
Enable the hourly time signal.
Enabling the Hourly Time Signal
l
Hand Movement and Watch
Screen Indications
Q1
I don't know what mode the watch is
in.
You can determine the current mode by
checking the watch display. Use (B) to
navigate between modes.
Navigating Between Modes
l
Q2
The second hand is jumping at two-
second intervals.
Battery power is low. Keep the watch exposed
to light until it recharges sufficiently.
Charging
l
Q3
All hands are stopped and buttons do
not work.
The battery is dead. Keep the watch exposed
to light until it recharges sufficiently.
Charging
l
Q4
The hands suddenly start moving at
high speed.
This is due to the reason (or one of the
reasons) below, and does not indicate
malfunction. Simply wait until normal hand
movement resumes.
The watch is recovering from a power
●
saving state.
Power Saving Function
l
A time calibration signal is being received
●
and the time setting is being adjusted.
Time Adjustment Using a Time Signal
l
Q5
Hands are stopped and buttons do
not work.
The watch is in the charge recovery mode.
Wait until the recovery process is complete
(for about 15 minutes). The watch will recover
more quickly if you place it in a brightly lit
location.
36