Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for TP-Link Tapo T300
Summary of Contents for TP-Link Tapo T300
- Page 1 User Guide Tapo Smart Water Leak Sensor © 2023 TP-Link 1910013487 REV1.0.0...
-
Page 2: Table Of Contents
Contents About This Guide ···················································· 1 Introduction ······························································· 2 Appearance ······························································· 3 Tapo Smart Ecosystem ······································· 4 Set Up Your Smart Sensor ································· 5 Use Your Smart Sensor ······································· 7 How to Reset Your Smart Sensor ·················· 9 How to Replace Battery ·····································10 Authentication ························································11... -
Page 3: About This Guide
Ignoring this type of note might result in a malfunction or damage to the device. Note: More Info • Specifications can be found on the product page at https://www.tapo.com. • Our Technical Support and troubleshooting information can be found at https://www.tapo.com/support/. • The setup videos can be found at https://www.tp-link.com/support/setup-video/#smart-sensors. -
Page 4: Introduction
• 3 Year+ Battery - Uses two replaceable AAA/LR03 batteries (pre-installated out of box) and provides you with up to three years of protection. Receive in-app reminders when the batteries are low. environments. *Battery life of up to 3 years is based on TP-Link's laboratory results when in standby mode. Actual battery life may vary depending on working conditions and... -
Page 5: Appearance
Appearance Sensor Probes Control Button Sensor Probe Sensor Probe Sensor Probe Buzzer Battery Compartment 2 AAA/LR03 batteries pre-installed. Control Button LED Indicator Single press Blinking Enter pairing mode Silence alarm; Blinks Adjusted alarm volume Test connection with the hub. once level to Mute Double press Blinks... -
Page 6: Tapo Smart Ecosystem
Tapo Smart Ecosystem Tapo is the easy way to turn your home into a smart home. With the Tapo Hub as a bridge, Tapo Smart Sensor works with a wide range of Tapo accessories. So you can easily control and monitor your home from anywhere. Temperature &... -
Page 7: Set Up Your Smart Sensor
Set Up Your Smart Sensor Watch setup videos at https://www.tp-link.com/support/download/tapo-t300/ Before You Start 1. Set Up Your Sensor 2. Power Up & Check LED A Tapo Hub is required. Make sure your Tapo Tap the button in the Tapo app, tap Remove the battery insulation tab to power up Hub’s firmware is updated to the latest version... - Page 8 3. Test Your Sensor 4. Place Your Sensor After setup, single press the control button on Lay the sensor flat to monitor water leaks. your sensor and check if the hub sounds an alarm.
-
Page 9: Use Your Smart Sensor
Use Your Smart Sensor After you successfully set up your hub and sensor, you will see your devices listed on the home page. With the Tapo app, you can view and manage your devices and get instant notifications anytime, anywhere. Home Page Home Page Settings Status Page... - Page 10 Featured Smart Actions Device Settings The sensor can work with other Tapo devices Check/edit the basic info, set notifications to automate your home. You can customize schedules, adjust the alarm volume, or remove smart actions based on the templates. your device from your account.
-
Page 11: How To Reset Your Smart Sensor
How to Reset Your Smart Sensor Option 1. Via the Button Option 2. Via the Tapo App Press and hold the button for at least 5 seconds until the LED starts Long press the card on the home page and tap or go to the Device Settings blinking. -
Page 12: How To Replace Battery
How to Replace Battery a. Remove the two screws securing the batteries and remove the b. Replace with the new batteries (AAA/LR03). back cover. Two screws securing batteries... -
Page 13: Authentication
Authentication FCC Compliance Information Statement Product Name: Tapo Smart Water Leak Sensor Model Number: Tapo T300 Responsible party: TP-Link USA Corporation Address: 10 Mauchly, Irvine, CA 92618 Website: http://www.tp-link.com/us/ Tel: +1 626 333 0234 Fax: +1 909 527 6804 E-mail: sales.usa@tp-link.com... - Page 14 We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and the equipment is properly maintained and operated.
- Page 15 The device complies with RF specifications when the device used at 20 cm from your body. Restricted to indoor use. UKCA Mark UK Declaration of Conformity TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of the Radio Equipment Regulations 2017.
- Page 16 The original UK declaration of conformity may be found at https://www.tapo.com/support/ukca/ Korea Warning Statements: 당해 무선설비는 운용중 전파혼신 가능성이 있음. NCC Notice 注意！ 取得審驗證明之低功率射頻器材，非經核准，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。 低功率射頻器材之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。 前述合法通信，指依電信管理法規定作業之無線電通信。 低功率射頻器材須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。 Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам нормативних документів та вимогам, що...
- Page 17 • Do not ingest battery, Chemical Burn Hazard CAUTION! Risk of explosion if the battery is replaced by an incorrect type CAUTION! Avoid replacement of a battery with an incorrect type that can defeat a safeguard. Avoid disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion. Do not leave a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;...
- Page 18 • Do not submerge the battery in water, or wet the battery. • Do not use or leave the battery near fire or in a car under the blazing sun. Such a high temperature may cause damage of the protecting device in the battery, which may result in an abnormal reaction, and then heat generation, explosion, or fire.
- Page 19 • Do not leave the battery in a equipment if it generates an odor and /or heat, changes color and / or shape, leaks electrolyte, or causes any other abnormality. • Do not use the battery in the place where the static electricity (more than the limit of the manufacturer’s guarantee) occurs. Otherwise, the protecting device in the battery might be damaged and cause heat generation, explosion, or fire.
- Page 20 Symbol Explanation Caution, risk of electric shock Energy efficiency Marking Protective earth Earth Frame or chassis Functional earthing Caution, hot surface Caution Operator’s manual Stand-by “ON”/”OFF” (push-push) Fuse...
- Page 21 Symbol Explanation Fuse is used in neutral N RECYCLING This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.