Focusrite Vocaster HP60v - Closed-Back Studio Headphones Manual

Focusrite Vocaster HP60v - Closed-Back Studio Headphones Manual

Also See for Vocaster HP60v:

Advertisement

Focusrite Vocaster HP60v - Closed-Back Studio Headphones Manual

Introduction

Hear your show in perfect detail with the Vocaster HP60v closed-back studio headphones. The Vocaster HP60v headphones let you hear your show as the world will. The Vocaster HP60v headphones include:

  • A lightweight adjustable cushioned headband for extended listening periods.
  • Screw-on 6.35mm stereo jack adaptor to use the Vocaster HP60v headphones with all your devices.
  • Wide, smooth frequency range to accurately monitor your recordings.
  • Closed-back design to isolate external noise and provide the best conditions for monitoring.

The closed-back design stops your microphone picking up your mix and the comfortable headband means you can tell your stories and produce your show for as long as you like.

Dimensions

Dimensions

Setup

Using the 6.35mm Jack Adaptor
You can use your Vocaster HP60v headphones with most audio devices however not all audio equipment uses the same size headphone connector.
To connect to your Vocaster, or most audio interfaces, you need to use the included 6.35mm jack adaptor. To connect to smaller devices like a laptop or phone you need to remove the 6.35mm jack adaptor by unscrewing it from the headphone cable.
Screw on the 6.35mm jack adaptor clockwise to connect the headphones to your Vocaster or audio interface:
Using the 6.35mm Jack Adaptor

Vocaster HP60v FAQs

The headphone jack is too big/small to fit the headphone output on my device
The Vocaster HP60v headphones include a screw on 6.35mm jack adaptor. For smaller devices like phones and computers you need to unscrew the adaptor (anti-clockwise) to use your headphones.

Can I use the Vocaster HP60v headphones with any device?
Yes, you should be able to use the Vocaster HP60v headphones with almost any device, other interfaces, phones, laptops, mixing consoles and more

Are the Vocaster HP60v headphones on-ear or over-ear headphones?
The Vocaster HP60v headphones are closed-back over-ear headphones.

Specifications

Technical Specifications

Performance
Impedance 32Ω
Sensitivity 98dB ±3dB
Frequency Response 20Hz - 20kHz
Maximum Power 1.2W
Physical Characteristics
Loudspeaker Diameter 50mm
Cable Length 3m (approximately)
Connector 3.5mm Stereo Jack
6.35mm screw-on adaptor
Weight (including cable) 288g (10.15 oz)

Accessories and Spare Parts

Part Part Number
Gold screw-on 6.35mm stereo jack adaptor - HP60v MISC002200
Single ear cushion (left or right) - HP60v MISC002201

To get spares for your Vocaster HP60v headphones please either contact our Spares team or speak to your local distributor:
Contact our Spares Team: support.focusrite.com
Contact your local distributor: stockists.focusrite.com

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Focusrite Vocaster HP60v - Closed-Back Studio Headphones Manual

Advertisement

Need Assistance?

Do you have a question about the Vocaster HP60v that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents