Chamberlain PILCEV, PILCEV-P1, PILCEVC, PILCEVC-P1 - SMART LAMP CONTROL Manual

OVERVIEW

The Smart Lamp Control offers a convenient way to control the lights in your home. It can be programmed to be controlled from anywhere with your smartphone and the Chamberlain MyQ ® App*. The Smart Lamp Control is also compatible with up to 8 Security+ 2.0 ® remote controls OR a combination of up to 8 MyQ ® enabled garage door openers. This product is not recommended for control of household appliance or fans. Not for use with 3-way or 4-way switch combinations.

SPECIFICATIONS

Fluorescent 600W / 5A
Tungsten 600W / 5A
LED 600W / 5A
Electronic Ballast (Fluorescent) 599W / 4.99A
Re-lamp with listed SBCFL only, 599W total, maximum

To prevent possible SERIOUS INJURY or DEATH from electrocution or fi re, the light control is ONLY for indoor use.

This product can expose you to chemicals including lead, which are known to the State of California to cause cancer or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov

MODES OF OPERATION

The Smart Lamp Control can be programmed to the MyQ^® app*, to a Security+ 2.0^® remote control, or to a MyQ^® enabled garage door opener.

SMARTPHONE OPERATION:
Allows you to activate the Smart Lamp Control from your smartphone or tablet and set schedules to switch your lights on/off at customized times.

REMOTE CONTROL OPERATION:
Allows you to activate the Smart Lamp Control from a remote control.

GARAGE DOOR OPENER OPERATION:
Allows you to synchronize the Smart Lamp Control with your garage door opener lights. Example: The garage door opener lights are set to automatically turn off after 4 ½ minutes, the Smart Lamp Control will also turn off after 4 ½ minutes.

INSTALLATION & PROGRAMMING

1. Plug the lamp into the Smart Lamp Control and plug the Smart Lamp Control into an electrical outlet (the LED on the Smart Lamp Control will flash). NOTE: Make sure the lamp is switched ON.
   
2. If the lamp is not ON, press and release the Power button on the Smart Lamp Control to turn the lamp ON.
   
3. Press and release the Learn button on the Smart Lamp Control (the LED on the Smart Lamp Control will light).
   
4. • Download the Chamberlain MyQ ® App*.
   • Create or sign-in to your account and follow the in-app instructions to add the Smart Lamp Control to your MyQ ® account.
     
     OR
     Press the button on the remote control.
     
     OR
     Press the Learn button on the garage door opener.
     The lamp's light bulb will blink and the LED on the Smart Lamp Control will turn OFF when the device has been programmed.
     

*Smartphone control requires a MyQ^® Garage, Smart Garage Hub, MyQ^® Internet Gateway, or Wi-Fi^® Garage Door Opener.

TO ERASE ALL PROGRAMMING

Press and hold the Learn button on the Smart Lamp Control for 6 seconds. All programming is now erased.

1-800-528-9131
www.chamberlain.com