Advertisement
UNPACK CARTON
& INSTALL
HANDLE
ACAUTION:
Be careful of exposed
staples when handling or disposing
of
cartoning material.
IMPORTANT:
When unpacking and
assembling tiller, be careful not to stretch
or kink cable(s).
• Cut cable ties securing handle column.
• Remove all packing from carton.
• Secure handle column to handle mount
using two (2) carriage bolts and two (2)
flange Iocknuts. Tighten both flange
Iocknuts securely.
• Remove packing material from handle
assembly.
• Route tine control cable through plastic
cable clip on handle column.
• Insert plastic cable clip into hole in
handle column.
• Cut cable ties securing tiller to skid.
• Cut away carton and remove tiller from
skid by pulling backwards.
Tine Control_
Tine Control Cable
Handle Moun
umn
Tine
Control
/'
Carriage _"%
Bolts
I-_% _;_ S
/
Flange
Locknuts
INSTALL
DEPTH STAKE
ASSEMBLY
• Loosen nut "A".
• Insert stake support between engine
bracket halves with stake spring down.
• Bolt stake support to engine brackets
with bolts, lock washers and nuts.
Tighten securely. Tighten nut "A".
• Depth stake must move freely. If it does
not, loosen support bolt.
\
Engine Bracket Halves
Depth Stake
Su
Depth
Stake
Hex Bolts, Lockwashers,
and Hex Nuts
HANDLE
HEIGHT
• Handle height may be adjusted to better
suit operator.
(See "HANDLE
HEIGHT"
in the Service and Adjustments
section
of this manual).
TILLING
WIDTH
• Tilling width may be adjusted to better
handle your tilling conditions
(See "TINE
ARRANGEMENT"
in the Service and
Adjustments
section of this manual).
TINE OPERATION
• Check tine operation
before first use.
(See "TINE OPERATION
CHECK" in
the Service and Adjustments
section of
this manual).
6
Advertisement
