Table of Contents
Advertisement
Notes on installation
Important note
The supplied package contains 2 plastic
clamping springs and 2 metal pins which can
be used for additional fixing of the decor
panels in the frame.
When the decor panel has been fitted, the
clamping spring is to be engaged in the
available recess between door decor frame
and control panel frame and pressed in to its
fullest extent. Then insert the filling pin and
pinch off projecting end (see illustration).
In the event of any possible decor panel
change, the foregoing mounting is to be
removed by prizing off with a screwdriver,
care being taken to prevent damage to the
decor frame. The used parts are to be
replaced by new ones during re-installation.
The individual parts can be ordered from the
sen/ice centre under the following part
numbers:
Clamping spring
Part No. 646 054 470
Filling pin
Part No. 646 056 660
Technical data
Capacity as per I EC Publ. 436
12 standard place settings
including serving utensils
Water pressure: 1 to 10 bar
This appliance meets the radio interference
suppression requirements of EC Directive
82/499 EC and the standards concerning the
effects of electrical appliances on power
systems EN 60 555 Parts 1—3 / DIN VDE 0838
Parts 1—3, June 1987.
The consumption data stated In this manual
refer to the comparison programme
"Normal 65°C".
Detergent dosage:
5 g in pre-wash sequence
20 g in wash sequence
Decor panel dimensions:
Free-standing appliance:
H 590 X B 580 mm
Clamping thickness:
Advertisement
Table of Contents
