Advertisement
Installation
Unpacking
Having removed the outer carton,
reinforcing angles, and polythene
wrapping, you must take out the internal
packing which protected the appliance's
'works' during transit.
1
Using the plastic spanner provided,
remove the three large bolts from the
back of the machine to free the washing
drum (figure 1).
2
Each bolt leaves behind a plastic spacer
inside the machine, this should be worked
loose by inserting a screwdriver into the
bolt hole, allowing the spacer to drop to
the bottom of the machine.
3
Lay the machine carefully on its back to
reveal two pieces of polythene bands in
the base (figure 2).
First pull band A, on left hand side then
pull band B on the right hand side to
withdraw the remaining internal packing,
taking care not to catch and damage any
of the appliance's internal components in
the process.
4
Finally, lift the appliance off the
polystyrene base packing and remove the
plastic spacers you worked loose earlier.
These spacers, together with the three
large bolts and other internal packing
should be kept in a safe place so they can
be used if the machine has to be
transported again.
7
Advertisement
