Timer Operations; Sleep Timer; Timer Playback - Aiwa NSX-DS50 Operating Instructions Manual

TIMER OPERATIONS
Sleep timer
Tums off the unit automatically after a specified time.
1 Press SLEEP on the remote control.
"SLEEP" appears on the display.
2 Press <¢<@ or & repeatedly to set the sleep
timer duration.
With each press, the timer duration changes in 5-minute
steps between 5 to. 240 minutes. If there is no button input
for 4 seconds, the current setting is entered automatically.
The unit turns off after the selected time.
© MULTI JOG is also available in place of << or >.
Tip:
The display is dimmed while the sleep timer is active.
To check the remaining time until the unit turns off
Press SLEEP on the remote control. The remaining time is
displayed for 4 seconds.
To cancel the sleep timer
Press SLEEP twice on the remote contro! so that "SLEEP
OFF" is displayed.
24
Timer playback
Turns on the unit at a specified time for the specified duration.
Make sure the clock is set correctly.
1 Press one of the function buttons to select the
desired playback source.
2 Press TIMER.
"®" indicator lights up and "®@ PLAY" appears on the
display. Then, the timer-on time and the source name
appear alternately on the display.
3 Press << or > to set the timer-on time, then
press HESET or ENTER.
If <4<4 or BP is not pressed within 6 seconds, you
will exit the timer setting mode and the previous setting,
however, is entered.
© MULTI JOG is also available in place of <<¢ or >>.
4 Press << or ®P to set the timer-activated
duration, then press ESET or ENTER.
With each press, the timer-activated duration changes in
5-minute steps between 5 to 240 minuies.
If there is no button input for 4 seconds, the current setting
is entered automatically.
© MULTI JOG is also available in place of << or >P.
5 Adjust the volume and tone for timed playback.
Ifthe volume level is set to 21 or higher, it is automatically
turned down to 20 when the unit is turned on by the timer.
6 Prepare the source.
To play CD(s), load disc(s).
To play the radio, select the band and tune in to the desired
station.
To play a tape, insert the tape.
To play external equipment conn the DIGITAL IN
PCM/DOLBY DIGITAL) OPTICAL (VIDE DVD) j
or the VIDEO/AUX/DVD jacks, set an external timer for
the equipment so that its playback begins at the same
time.
7 Press POWER ®STANDBY/ON to turn the unit
off.
"®" remains on the display to indicate the timer standby
mode.
At timer-on time, the unit turns on and plays the selected
source. After the specified timer-activated duration, the
unit turns off again.
¢ Timer playback will not begin unless the unit is turned off
first.
Connected equipment cannot be turned on or off by the built-
in timer of this unit. Use an external timer.
¢ The timer source can be changed with the function buttons
before completing step 3.