Download Print this page

Zanussi WD 9091 Operating Instructions Manual page 20

Hide thumbs Also See for WD 9091:

Advertisement

Using fabric conditioners
When you want to use a conditioner, put
the measured amount (follow
manufacturers' instructions) into
compartment "e" in the washing powder
dispenser at the same time as you put in
the washing powder. Be careful not to
fill the compartment above the level of
the filter. The conditioner will be
automatically used by the machine at the
appropriate time. Remember to close the
drawer gently (see above).
To start the machine
Check that:
the main switch is cn;
the door is properly closed;
the water is turned on.
Select the programme required by
turning the programme selector dial
clockwise to the required letter. Pull out
the knob. The pilot light will then come
on and the machine will start. When
selecting the drying cycle, you also have
to set the required drying time by
turning the selector dial. The machine
will automatically carry out all the
operations up to the end of the chosen
programme. Then it will stop.
The pilot light will not go out until the
selector knob is pushed in to switch the
machine off.
If, after the start of a programme, you
find you have selected the wrong one,
push the selector knob in to stop the
machine. Then turn the dial clockwise to
the correct position and pull the knob
out to restart the washing cycle.
At the end of the programme push the
knob in to switch the machine off.
20
Unloading the clothes
The drum door remains automatically
locked for 1-2 minutes after the machine
has been switched off. You can then open
the door and unload the machine. If you
have been using a gentle wash cycle do
not forget to set the machine to drain
the water (programme X or Z) before
opening the door.
Additional programmes
Half-load programme/ Automatic drying
Use this for smaller loads of cotton and
linen items — 2kg (4lb) max. Press in the
pushbutton marked 1%, then select the
appropriate programme. Do not, however,
use any of the gentle action programmes
as these need a higher water level, than
is allowed for the halfload programme.
See page 10.
Spin only
This programme can be used to remove
water from hand washed articles or any
laundry which may have got wet but
does not need washing. For example,
washing left on the line during a
rainstorm. See pages 13 and 15.
Special treatments
If you want to treat an article with
fabric conditioner without washing it
first, you can do this on either
programme J or W.

Advertisement

loading