Accessory Jack; Chapter 3. - Basic Use; Power And Volume; Turning The Unit On - Baofeng UV-5R EX User Manual

Table of Contents

Advertisement

Visit Radioddity.com For Downloads And Help

Accessory jack

The accessory jack on the Baofeng UV-5R EX is a Kenwood compatible two (2)-pin design
Figure 2.4. Typical 2 pin Kenwood headset configuration.
To attach accessories such as headsets, speaker-mics or programming cables,
align the connectors and push in fully.
18
Visit Radioddity.com For Downloads And Help
Before we turn the power on, make sure you have attached the battery and antenna as
described in Chapter 1, Initial setup.

Turning the unit on

To power the radio on, simply rotate the volume/power knob clockwise until you hear a
"click". If your radio powers on correctly there should be an audible double beep after about
one second and the display will show a message or flash the LCD depending on settings
for about one second (see "38 PON MSG - Power On Message" in Appendix B' Menu
definitions). Then it will display a frequency or channel. If the Voice prompt is enabled, the
voice will announce "frequency mode" or "channel mode".
You can get additional information about your radio when you turn it on by holding down
miscellaneous keys as you turn it on.

Chapter 3. - Basic Use

Power and volume

Figure 3.1 First power-on, display
19

Advertisement

Table of Contents
loading

Table of Contents