Pioneer CLD-M450 Operating Instructions Manual page 23

LD/CDV/CD
CLD-M450/CLD-M401
Front panel buttons and remote control unit buttons with the same
name or mark have the same function.
CLD-M301
3-inch CD
8-inch LD
[Caution
@ Only one disc can be loaded at a time on each disc tray.
CDs and player to be damaged.
center disc tray.
the surrounding disc tray) and then load an LD
@ When a CD is loaded on the center disc tray, do not set and play an LD. This will cause
@ When loading an LD, make sure that CDs are returned to surrounding disc trays properly.
{f the power of this unit is turned off with an audio timer or the power cord is unplugged
and then plugged during CD playback, the CD previous played may be left loading on the
in such case, open the disc table, remove the disc from the center disc tray (or put it on
5
or
es |
?
Remote control unit
@ With CDV discs, the video part is
played first.
@ When 5 discs are set on the
surrounding disc trays, playback starts
from disc No. 1.
To avoid malfunctions, be especially careful about the following
points.
@ Do not place any object other than a disc on the disc table.
@ Do not move the player while a disc is playing. This will cause
the disc to be scratched.
@ Be careful not to catch your finger in the disc table section
while the disc table is being retracted into the unit. Also, be
careful that children do not put their hands into the inside of the
unit while the disc table is open. This may cause injury.
@ When an LD is loaded, CDs or CDVs cannot be played.
® During CDs (or CDVs) playback or disc change mode, if the AC
power cord is unplugged or the amplifier's power switch is
turned off (when the power cord of the player is connected too
SWITCHED AC OUTLET of the amplifier), °1-CD" is displayed
on the display window when the power is turned back on. In
this, mode, the DISC NUMBER buttons cannot be operated.
Open the disc table, remove the disc from the center tray and
put the disc on the surrounding disc tray.
Precautions concerning disc loading
e An LD can be loaded and played without removing CDs or
CDVs, However, remove the LD to play CDs or CDVs.
® Before loading CDs or CDVs, remove the LD
® With this unit, playback of all types of discs is carried out without
the use of adaptors. Therefore, de not use any type of adaptor
with this unit.
@ When a CD or CDV is placed on the center tray, playback is
performed with the center tray disc only, "1-CD" is displayed
on the display window and the DISC NUMBER buttons cannot
be operated.
Last Memory function:
If the power is turned off during LD playback, a playback position
slightly ahead of the current frame is stored in the unit's memory
{Last Memory}. When the power is turned back on and playback
begins from the memorized position by pressing /H or >.
23
<VRB1070>