3. Transportation and Handling
3. Transportation and Handling
3.1 Transportation
Transport the product as close to the installation location as practical before unpacking.
CAUTION
!
•
Do not put any material on the product.
3.2 Handling of Indoor Unit
WARNING
!
•
Do not insert any objects into the indoor unit and check to ensure that none exists in the indoor unit
before the installation and test run. Otherwise, a fire or failure, etc. may occur.
CAUTION
!
•
Do not hold the resin covers when holding or lifting the indoor unit.
To avoid damage to the resin covers, before lifting or moving the indoor unit, put a cloth on the
resin covers.
Remove the air inlet grille and resin side cover before installation.
•
Remove the air inlet grille
(1) Open the air inlet grille after removing screw covers and fixing screws as is shown in Fig 7.1 of
section 1.
(2) Carefully push the air inlet grille away from the mounting plate of indoor unit.
(3) Remove the air inlet grille.
•
Remove the resin side cover
(1) Remove fixing screw of side cover.
(2) Carefully push the side cover away from the indoor unit approximately 10mm forward.
(3) Remove the resin side cover.
Air Inlet Grille
Resin
Side Cover
Top Side of the Unit
Resin
Side Cover
INCORRECT
Fig.3.1 Side Covers
-6-