Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for LG WD-1244RDS
Summary of Contents for LG WD-1244RDS
- Page 1 WD-1244(0~9)RDS WD-1444(0~9)RDS WD-1644(0~9)RDS GL-5014WRD...
-
Page 2: Table Of Contents
roduct Feature Direct Drive System The advanced Brushless DC motor directly drives the drum without belt and pulley. Water Circulation Spray detergent solution and water onto the load continuously. Clothes are soaked more quickly and thoroughly during wash cycle. The detergent suds can be removed more easily by the water shower during rinse cycle. -
Page 3: Warnings
arnings READ ALL INSTRUCTIONS AND EXPLANATION OF THE INSTALLATION BEFORE USE For your safety, the information in this manual must be followed to minimize WARNING! the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. IMPORTANT SAFETY INSTRUCTIONS WARNING To reduce the risk of fire, electric shock, or injury to persons when using... - Page 4 arnings To minimize the risk of fire in a tumble dryer, the following should be observed: • Items that have been spotted or soaked with vegetable or cooking oil constitute a fire hazard and should not be placed in a tumble dryer. Oil-affected items can ignite spontaneously, especially when exposed to heat sources Such as in a tumble dryer.
-
Page 5: Specification
pecification Drawer Name : Front loading washing machine Power supply : 220 - 240V~, 50Hz Size : 600mm(W)×640mm(D)×850mm(H) Weight : 66kg Wash Capacity : Refer to the Rating Label Dry Capacity : Refer to the Rating Label Max. Watt : 2100W(Wash) / 1500W(Dry) / 1100W(Steam) Spin speed : No Spin/400/800/1000/1200 [WD-1244(0~9)RDS] No Spin/400/800/1000/1400 [WD-1444(0~9)RDS/GL-5014WRD]... -
Page 6: Installation
nstallation Install or store where it will not be exposed to temperature below freezing or exposed to the weather. Properly ground washer to conform with all governing codes and ordinances. The base opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor. - Page 7 nstallation Installation place requirement Level floor : Allowable slope under entire washer is 1˚ Power outlet : Must be within 1.5 meters of either side of location of washer. Do not overload the outlet with more than one appliance. Additional Clearance : For wall, door and floor modeling is required.
- Page 8 nstallation ■ Electrical connection 1. Do not use an extension cord or double adapter. 2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agents or similarly qualified person in order to avoid a hazard. 3.
- Page 9 nstallation This equipment is not designed for maritime use or for use mobile installations such as caravans, aircraft etc. Turn off the stopcock if the machine is to be left for any length of time (e.g. holiday), especially if there is no floor drain(gully) in the immediate vicinity. When disposing of the appliance, cut off the mains cable, and destroy the plug Disable the door lock to prevent young children being trapped inside.
- Page 10 • If possible install the washer in one of the corners of the room, where the floor is more stable. ※ Insert the rubber cups to reduce vibration. ※ You can obtain the rubber cups (p/no.4620ER4002B) from the LG svc dept. Important! •...
-
Page 11: Care Before Washing
are before washing Before the first washing Select a cycle (COTTON 60°C, add a half load of detergent) allow the unit to wash without clothing. This will remove residues and water from the drum that may have been left during manufacturing. Caring before washing 1. -
Page 12: Adding Detergent
dding detergent Adding detergent and fabric softener 1. The Dispenser Drawer • Main wash only ➔ • Pre Wash + Main Wash ➔ 2. Adding Fabric Softener • Do not exceed the maximum fill line. Close the dispenser drawer slowly. Overfilling can cause early dispensing of the fabric softener which could stain clothes. - Page 13 dding detergent ❋ Tips 3. Detergent dosage Full load : according to • The detergent should be used according to the manufacturer’s recommendation. instruction of the detergent manufacture. Part load : 3/4 of the normal amount. • If too much detergent is used, too many suds Minimum load : 1/2 of full load.
-
Page 14: Function
unction Recommended courses according to the laundry type Water Maximum Program Fabric Type Temp. Option (Option) Load (Option) Color fast garments 60°C (shirts, night dresses, Cotton (Cold, 30°C, - Time Delay - Low Temp. Rating pajamas...)and lightly soiled 40°C, 95°C) - Steam Wash - Iron Dry white cotton(underwear) -
Page 15: How To Use Washer
ow to use washer Allergy Care 2. Manual Selecting 1. Cotton automatically selected upon power on. • Press the Power button to start. • Select the conditions which you want to • Press the Power button to start. use, by pressing each button. •... - Page 16 ow to use washer Allergy Care (4) (5) (9) (10) (11) (1) Button : Power (5) Button : Steam Wash (9) Button : Child Lock (2) Dial : Program (6) Button : Temperature (10) Button : Tub Clean (3) Button : Start/Pause (7) Button : Spin (11) Dial : Dry (4) Button : Time Delay...
- Page 17 ow to use washer Allergy Care Start/Pause Time Delay 1. Start Preparing washing before starting “Time Delay” - Turn on the water tap. • This Start/Pause button is used to start - Load laundry and close the door. wash cycle or pause the wash cycle. - Place the detergent and fabric softener in 2.
- Page 18 Allergy Care ow to use washer Steam Wash Refresh I Refresh cycle • For slightly wrinkled clothes which have been stored for an extended time. It just makes wrinkled clothes easy to iron (Do not load wet clothes). • Wrinkles will be reduced. I How to use Refresh cycle 1.
- Page 19 Allergy Care ow to use washer Option Water Temp. • By pressing the Temp. By pressing each button, the water the button, each temperature can be function will be selected. selected. - Cold - 30˚C / 40˚C / 60˚C / 95˚C 1.
- Page 20 Allergy Care ow to use washer Care Tub Clean Child lock If you choose to lock the buttons on the Care Tub Clean course can be set by pressing control assembly to prevent tampering, this and holding Intensive and Pre Wash button function may be selected.
- Page 21 ow to use washer Spin 2. No spin • If “No Spin” is selected, the washer stops after draining water. 3. Spin Only 1. Press the Power button. [WD-1644(0~9)RDS] [WD-1444(0~9)RDS/ [WD-1244(0~9)RDS] 2. Set the desired spin speed by turnning spin GL-5014WRD] dial.
- Page 22 ow to use washer 1. Drying Automatic guide • Use your Automatic Cycles to dry most loads. Electronic sensors measure the temperature of the exhaust to increase or decrease drying temperatures for faster reaction time and tigher temperature control. • If a load is not as dry as you like, complete drying using a time cycle.
- Page 23 ow to use washer • Your dryer can handle a load of up to 4kg • "Cooling Down" is to prevent wrinkles from dry weight of articles. forming caused by not removing the laundry from the tub after cycle is done. •...
- Page 24 ow to use washer Display 3. Completion of washing • When washing cycle is completed, “ ” is displayed on the “Multi display”. 4. Time left • During washing cycle, the remaining 1. Special function display washing time is displayed. •...
-
Page 25: Maintenance
aintenance ❋ Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock to avoid electrical shock hazards. ❋ When disposing of the appliance, cut off the mains cable, and destroy the plug Disable the door lock to prevent young children being trapped inside. The water inlet filter - "... - Page 26 aintenance The drain pump filter ❋ The drain filter collects threads and small objects left in the laundry. Check regularly that the filter is clean to ensure smooth running of your machine. CAUTION First drain using the drain hose and then open the pump filter to remove whatever any threads or objects.
- Page 27 aintenance Dispenser drawer ❋ After a while detergents and fabric softeners leave a deposit in the drawer. • It should be cleaned from time to time with a jet of running water. • If necessary it can be removed completely from the machine by pressing the catch downward and by pulling it out.
- Page 28 aintenance The water circulation nozzle & Steam nozzle • Clean the water circulation nozzle and Steam nozzle, if clogged. Cleaning your washer 1. Exterior Proper care of your washer can extend its life. The outside of the machine can be cleaned with warm water and a neutral non abrasive household detergent.
-
Page 29: Troubleshooting Guide
roubleshooting guide ❋ This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately. When the machine does not function properly or does not function at all, check the following points before you contact your service provider. Symptom Possible Cause Solution... - Page 30 roubleshooting guide Symptom Possible Cause Solution Washer does not start • Electrical power cord may not Make sure plug fits tightly in wall be plugged in or connection outlet. may be loose. • House fuse blown, circuit Reset circuit breaker or replace fuse. breaker tripped, or a power Do not increase fuse capacity.
- Page 31 roubleshooting guide Symptom Possible Cause Solution • Water supply is not adequate in area Check another tap in the house. • Water supply taps are not completely Fully open tap. open. • Water inlet hose(s) are kinked. Straighten hose(s). • The filter of the inlet hose(s) are Check the filter of the inlet hose(s).
-
Page 32: Terms Of Warranty
erms of Warranty Disposal of your old appliance 1. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC. 2. All electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities. - Page 35 P/No.: MFL31184288...