Table of Contents
Advertisement
Sigele]o)(=t-yaleleyilare
PowabieGauees
Power cannot be turned on.
¢ Check if the power cord is disconnected from the power outlet.
No audio.
¢ Check for faulty connection. (See pages 4 to 6.)
© Check for short-circuited speaker terminals.
© Check that the function selectors are correctly selected.
¢ The shorting plugs of the ADAPTOR jacks are disconnected.
© Check that the connected equipment, such as a graphic equalizer is
turned on.
© Check if the volume level of the rear speakers is set to minimum.
¢ Check if the monaural program source is played back in Dolby surround
mode.
¢ Check if the 3 CH. LOGIC mode is selected in the DOLBY Pro Logic
mode. (TA-E611 only) (See page 16.)
¢ Check if the batteries are exhausted.
© Check if the mode selector is set to USER STD in remote-control
operation using programmed signals. (See page 21.)
The remote-control signal cannot be
programmed.
The LEARN indicator does not light.
¢ Place both remote commanders apart from the source of noise.
¢ The batteries are exhausted. (See page 21.)
The LEARN indicator goes off after
© The internal memory capacity is full. (See page 21.)
flashing.
Programmable
Commander
23
Advertisement
Table of Contents
