True GDM-49-HC-TSL01 Installation Manual page 8

TRUE
glass door merchandisers
INSTALLING OPTIONAL CASTORS ON
GDM-10 AND GDM-12 MODELS
FINAL LOCATION
A. Place Styrofoam corners behind cooler for cushion and carefully
tilt unit on it's back.
B. Remove the louvered grill by removing four phillips-head
screws.
C. Remove the four bolts from the skid with an adjustable wrench,
and locate the four castors. Castors are placed inside cooler,
within the bubble wrap.
D. Install one castor in each of the four female threaded areas as
indicated.
NOTE: Two out of the four castors are designated with an "F" for
front. These are provided with hand-brakes. Position these castors in
FRONT of the unit.
E. When all castors have been threaded fully, replace grill and lift
unit; positioning it into its final location.
F. Ensure that the two front castors are positioned FORWARD
as illustrated and locked down with the hand-brakes.
WARNING: Unit may tip forward if procedure "F" is not strictly
followed.
G. Units final location should be adequately ventilated. Conditions
where heat exceeds 100ºF require an exhaust fan.
H. Ensure that the drain hose for hoses are positioned in the pan.
I. Free plug and cord from inside the lower rear of the cooler (Do
Not Plug In.)
WARNING: Warranty is VOID if ventilation is insufficient.
J. The unit should be placed close enough to the electrical supply
so that extension cords are NEVER used.
WARNING: Cabinet warranties are void if OEM power cord is
tampered with. TRUE will not warranty any units that are connected
to an extension cord.
K. Proper leveling of your TRUE cooler is critical to operating
success. Effective condensate removal and door operation will
be effected by leveling. Adjust castors or add shims.
7
. .
www truemfg com
POSITIONING OF THE
CASTOR IS CRITICAL.
ORIENT THE CASTOR IN
THE FORWARD POSITION
AS SHOWN.