Table of Contents
Advertisement
FAST-18T Radar Speed Display Trailer user Manual
screen, after approximately 5 seconds.
VIOLATOR ALERT 3: RB - RED AND BLUE FLASHING LIGHTS
The display will now show "RB" which effectively flashes the Red and Blue
flashing light pattern at the driver while displaying their speed. The operator
has 5 seconds to start pushing the button in-order to change the number
setting.
Note:
You can set the numbers even when the "Red & Blues" are flashing.
Press the button until the desired speed setting is reached. Once the desired
setting is reached, stop and wait for the next screen after approximately
5 seconds.
VIOLATOR ALERT 4: LF - FLASHING WHITE STROBE
The display will now show "LF". When drivers go over this setting, the white
flashing strobe. The operator has 5 seconds to start pushing the button in-
order to change the speed setting. Press the button until the desired speed
setting is reached. Once reached, stop and wait for the next screen to appear
after approximately 5 seconds.
VIOLATOR ALERT 5: FL - FLASHING SPEED
The display will now show "FL". When drivers go over this setting, they will
see their over-the-limit speed flash. The operator has 5 seconds to start
pushing the button in-order to change the speed setting. Press the button
until the desired speed setting is reached. Once reached, stop and wait for
the next screen to appear after approximately 5 seconds.
VIOLATOR ALERT 6: BL - BLANKING SPEED
The display will show "BL" which is the speed limit that the display will no
longer show the oncoming vehicles speed. This setting will prevent drivers
from increasing their speed over this speed limit to see how fast they
can go. Press the button until the desired speed setting is reached. Wait
approximately 5 seconds and the sign will go dark. The display is now in
service and operating in "Violator Alerts" mode.
NOTES:
After this last "BL" screen, all of the violator alert settings have been saved even after the sign is switched
ƒ
off. When the sign is turned on again, it will run through all of the modes and their speed settings for the
operator to review.
If changes are needed, press the sign mounted button for 5 seconds which will start the mode settings to
ƒ
display again. If using the key chain remote, hold the left button in for 1 second for the same effect.
If desired, the sign can be pre-set at your base facility for transportation and set-up at a different location.
ƒ
The violator alerts can be set in any order, but not at the same speed. If attempted, this setting will skip
ƒ
to the next available number. To get the best effect from the alerts, set the speeds at least 3-4 MPH
difference. If you wish to not use one of the violator alert settings, set the speed higher than blanking
speed threshold.
8
"Flashing White Strobe"
"Flashing Speed"
"Blanking Speed"
Advertisement
Table of Contents
