Additional Functions; Anti-Drip Function; Cleaning And Maintenance - TEFAL Ultimate 250 Manual

1800128603_01_FV96XXE0_110x154 20/12/12 11:30 Page3
• If you are ironing a fabric comprising a mixture of fibres: adjust the temperature
to the most delicate fibre.
• If you put your thermostat in the "MIN" position, the iron does not become hot.
Check that there is
water in the tank before
using the spray trigger.
Obtaining more steam
• Set the thermostat control to "MAX" or "
• Press the turbo steam button from time to time –
• To avoid water dripping onto your clothes, wait a few seconds before pressing again.
Hold the iron a few
centimetres from the
fabric so as not to burn
delicate fabrics.
Dry Iron function
• Adjust the temperature to the fabric being ironed.
• Set the steam control to
• You can iron when the light goes out.

Additional functions

Gliss/Glide Protect
• Your iron is equipped with a catalytic self-cleaning soleplate.
• Its exclusive coating permanently eliminates impurities generated during normal use.
• It is recommended that you always rest your iron on its support base to preserve its self-cleaning coating.
In normal use, the auto-
stop light is on!

Anti-drip function

• The automatic steam selection function is based on the fabric being ironed, which is integrated into your iron,
reduces the steam flow at low temperatures and prevents the iron from dripping onto your clothes.

Cleaning and maintenance

Descale your steam iron easily
Do not put any descaling
products (vinegar,
industrial descaling
agents...) to rinse out
your iron: they could
damage it.
Using the water spray trigger
• When ironing with the steam or dry function, press the spray trigger several times
in succession to remove stubborn wrinkles –
•••
".
fig.7.
Smoothing garments vertically
• Hang the garment on a hanger and hold the fabric using one hand. The steam
is very hot so you should always do this with the garment on a hanger – never
while someone is wearing it.
• Set the thermostat control to "MAX" –
• Pulse the turbo steam button
– fig.1.
autoclean soleplate
TM
Auto-stop safety function
• The electronic system cuts the power and the auto-stop light flashes if the iron
is placed on its support base for more than 8 minutes or left flat for more than
30 seconds – fig.10.
• To restart the iron, simply shake it gently until the light stops flashing.
• To prolong the steam performance, your iron is equipped with an integrated
limescale collector. This collector, which is located on the iron's support base,
automatically collects limescale that forms inside the iron.
• It is recommended that you clean the collector every 4 months. The amount of
scale collected will depend on the hardness of the water.
• BE CAREFUL: this operation should only be carried out when the iron has been
unplugged for more than one hour and has cooled down completely. To carry
out this operation, the steam iron must be close to a sink so that water can flow
from the tank when opened.
• Hold the iron in one hand and tilt it slightly, pointing the soleplate upwards.
3
fig.6.
fig.8.
– fig.7 and move from top to bottom – fig.9.
(depending on model)
(depending on model)
EN
DE
(spray)
FR
NL
ES
PT
IT
DA
SV
NO
FI
EL
HU
CS
SK
SL
SR
HR
RO
BG
TR
UK
RU
PL
ET
LV
LT