Systemlüfter; Removing The System Fan - Dell D17S005 Owner's Manual

Steps
1. Slide the intrusion switch into the slot on the chassis.
2. Route the intrusion-switch cable through the routing guides on the chassis.
3. Connect the intrusion-switch cable to the connector on the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in
Systemlüfter

Removing the system fan

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive
5. Remove the 3.5-inch hard drive
6. Remove the disk-drive
About this task
The following image indicates the location of the system fan and provides a visual representation of the removal procedure.
76 Entfernen und Installieren von vor Ort austauschbaren Einheiten (FRUs)
After working inside your
Before working inside your
if applicable.
if applicable.
cage.
computer.
computer.