Table of Contents
Advertisement
To retrain the device to use your voice:
1.
Press
.
2.
From the "Say a Command" page, touch
Adaptation > Adapt Voice > Start
3.
Hold the device so that the microphone is
approximately six inches away from your mouth
and you can clearly read the onscreen number
sequences.
4.
Repeat either the digits or words shown onscreen
using a normal tone of voice.
If the device cannot recognize your words, it will
continue to display the same information
onscreen.
5.
Repeat the previous step for the remaining sets of
digits or words.
6.
When you are finished with a full session, you will
reach a screen that reads, "Adapting."
94
Section 2H. Speech to Action
Settings >
.
Note
It is recommended that you perform the complete
Adapt Voice session at least once to achieve the
maximum benefit of this feature. If a partial
adaptation is performed, you can always return later
and resume the process from the halfway point.
Resetting Voice Recognition
1.
Press
.
2.
From the "Say a Command" page, touch
Adaptation > Reset Voice
voice dialog.)
3.
Touch
Yes
to reset the voice recognition
parameters or
to exit.
No
Settings >
. (The device displays a reset
Advertisement
Table of Contents
