Toshiba RAV-GM901CTP Series Service Manual page 66

<Wireless remote controller>
Remote controller address (A-B selection) setting
• When two or more signal receiving units are installed in a room, a unique address
can be set for each signal receiving unit to prevent interference.
• Address (A-B selection) must be changed on both signal receiving unit and wireless
remote controller.
• For the details of address change (A-B selection) on wireless remote controller, refer
to the owner's manual.
Turn off the indoor unit power supply. Turn on the bit 3 of DIP switch SW30 on the
signal receiving unit P.C. board.
The setting change is shown below.
Lower cace
DIP switch [SW30]
ON=follower OFF=header
4
ON=B OFF=A
3
Not used
2
Not used
1
Screw
Signal receiving unit
SW30
SW30
ON
1 2 3
- 66 -
4