Table of Contents
Advertisement
6. Remove the four screws securing the mechanism deck
assembly and remove the assembly in the direction of the
arrow,
At the same time, disconnect the flexible card wire from
the connector (CN3) of the SV-145 board and disconnect
the harness from the connector (CN1).
Note: When removing the assembly, take note of the
following.
e Hold the assembly at part A shown in the figure.
e Do not scratch the flexible card wire.
Attaching
7. Adjust the mechanism deck assembly with the dowels
(two) of the chassis and tighten the four screws.
9. Attach in the reverse order of steps 1 to 6.
"SECTION 3. ELECTRICAL ADJUSTMENTS".
2-4 (E)
2-4. REMOVING THE DISC IN EMERGENCIES
If the disc cannot be removed due to power supply failure
and ejection faults, remove it using the following procedure.
Required Tool
e Precision screwdriver 63.5 mm
Sony Part No.:7-721-051-10 (Precision screwdriver set)
Note: Always use the specified tool.
Procedure
1. Insert the precision screwdriver into the hole of the cam
from the hole at the rear side of the unit.
2. Rotate the cam in the clockwise direction once and then
in the counterclockwise direction.
Note: If the disc table does not move, without applying
excessive force, repeat step 2 until it can be pulled out
from the front panel.
3. Pull out the loading panel with your hand gently and
remove the disc on the disc table.
CDP-31 00.
Advertisement
Table of Contents
