Table of Contents
Advertisement
If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.
Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation.
The appliance...
salt indicator is lit
rinse aid indicator is lit
...is not working/will not start
...shows "F6 E7" or "F6 E1" or "H2O"
...shows "F6 E3"/wash program ended
too early (dishes are dirty and wet)
...shows "F8 E1"
...shows other fault display "Fx Ey"
Possible causes...
- Salt reservoir is empty. (After refill the salt
indicator may remain lit at the end of several
wash cycles).
- Rinse aid dispenser is empty.
- The appliance must be switched on.
- The dishwasher door doesn't close.
- "Delayed start" option is ON.
- Water tap closed.
- Water pressure too low.
- Bent water inlet hose or clogged inlet filters.
- Dirty or clogged filters or spray arms.
- Too little water in the dishwasher's water
system.
- Drain hose incorrectly fitted.
- High level of foam inside.
- Dirty filters.
- Kinked drain hose.
- Syphon hose connection closed.
- Appliance has technical defect.
After taking the above course of action, the fault message must be reset. In the majority of cases the fault is thus eliminated.
RESET:
Press the CANCEL/Off button.
Close the door.
Water drains automatically for up to 1 minute.
The appliance is now ready to be restarted.
- Refill reservoir with salt (for more information - see page 3).
- Adjust water hardness - see table, page 3.
- Refill dispenser with rinse aid (for more information - see page 4).
- Check the household circuit fuse if there is no power supply.
- Check if the dishwasher's door is closed.
- Check whether the "Delayed start" option (if available) has been selected. If it has, the
appliance will only start once the set time has elapsed. If necessary, RESET the appliance by
pressing CANCEL or start the cycle immediately by pressing START.
- The water tap must be open.
- The water tap must be fully open during water inlet (minimum capacity: 0.5 litres per
minute).
- The water inlet hose must not be bent and the relative inlet filter in the water tap connector
must not be dirty or clogged.
- Clean the filters and spray arms.
- Concave items (e.g. bowls, cups) must be arranged facing downwards in the rack.
- The drain hose must be fitted correctly (for high mounted appliances, leave min.
200-400 mm from the lower edge of the appliance) - see Assembly instructions.
- Repeat without detergent or wait until foam disappears.
- Clean the filters.
- The drain hose must not be kinked.
- The closure disk of the syphon hose connection must be removed.
- Call factory customer service (state fault display). Close the water tap.
What to do if...
Solutions...
EN -9-
Advertisement
Table of Contents
