Troubleshooting - Whirlpool WUC 3C24 Daily Reference Manual

TROUBLESHOOTING

Your dishwasher may not work properly.
Before contacting the Service Centre check if the problem can be solved by going through the following list.
PROBLEMS POSSIBLE CAUSES
The dishwasher The appliance has not been plugged in
won't start or does properly.
not respond to com-
Power outage.
mands.
The dishwasher door is not closed.
It does not respond to commands.
The dishwasher The wash cycle has not finished yet.
won't drain.
The drain hose is bent.
The sink drain pipe is blocked.
The filter is clogged up with food residues
The dishwasher The dishes are rattling against each.
makes excessive
An excessive amount of foam has been
noise.
produced.
The dishes are not The crockery has not been arranged prop-
clean. erly.
The spray arms cannot rotate freely, being
hindered by the dishes.
The wash cycle is too gentle.
An excessive amount of foam has been
produced.
The cap on the rinse aid compartment has
not been shut correctly.
The filter is soiled or clogged.
There is no salt.
MAINTENANCE AND TROUBLESHOOTING GUIDE
For more information, maintenance procedures and troubleshooting,
see the Use and Care Guide.
The Use and Care Guide can be obtained by:
• After-Sales Service; phone number see in warranty booklet.
• download from website: http://docs.whirlpool.eu
• use QR code
TECHNICAL DATASHEET
The technical data containing the energy consumption data can be
downloaded from the website: http://docs.whirlpool.eu
8
001
SOLUTIONS
Insert the plug into the socket.
The dishwasher starts automatically when the power returns.
Vigorously push the door until you hear the "click".
Switch off the appliance by pressing the ON/OFF button, switch it back on
after approximately one minute and reset the program.
Wait until the wash cycle finishes.
Check that the drain hose is not bent (see INSTALATION INSTRUCTION).
Clean the sink drain pipe.
Clean the filter .
Arrange the crockery correctly .
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers . Reset dishwasher by pressing the DRAIN button and
run new program without detergent.
Arrange the crockery correctly .
Arrange the crockery correctly .
Select an appropriate wash cycle .
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers .
Make sure the cap of the rinse aid dispenser is closed.
Clean the filter assembly .
Fill the salt reservoir .
CONTACTING AFTER-SALES SERVICE
When you contact the After-Sales Service,
you must provide the codes shown on the
rating plate attached to the left or right side
inside the door of the dishwasher. The
phone number is listed in the warranty
booklet or on the website:
http://www.whirlpool.eu
IEC 436
:
195145888.00
05/2016 - lr- Xerox Fabriano