Advertisement
5. ADC Calibration
5.1 Adjustment of RF / AV / S-VIDEO
* Required Equipments
8 Remote controller for adjustment.
8 MSPG-925FS Pattern Generator (Which has Video
Signal: 7 Color Bar Pattern shown in Fig. 1).
=> Model: 207 / Pattern: 65
5.1.1 Method of Auto RF / AV / S-VIDEO Color Balance
(NTSC-J).
1) Input the Video Signal: 7 Color Bar signal into AV1
2) Set the PSM to Dynamic mode in the Picture menu.
3) Press IN-START key on R/C for adjustment.
4) Press the G (Vol.+) key to operate the set, then it
becomes automatically.
5) Auto-RGB OK means the adjustment is completed.
5.2 Adjustment of Component
*Required Equipments
8 Remote controller for adjustment
8 MSPG-925FS Pattern Generator. (Which has 720p/60Hz
YPbPr output Pattern shown in Fig. 2)
=> Model: 216 / Pattern: 65
[Fig.1]
[Fig.2]
5.2.1 Method of Auto Component Color Balance
1) Input the Component 720p/60Hz 7 Color Bar (MSPG-
925FS model:216, pattern:65) signal into Component.
2) Set the PSM to Dynamic mode in the Picture menu.
3) Press IN-START key on R/C for adjustment.
4) Press the G (Vol.+) key to operate the set, then it
becomes automatically.
5.3 Adjustment of RGB
*Required Equipments
8 Remote controller for adjustment
8 MSPG-925FS Pattern Generator
(Which has XGA [1024*768] 60Hz 8 color bar 100%
pattern shown in Fig. 3 )
5.3.1 Method of Auto RGB Color Balance
1) Input the PC 1024x768 @ 60Hz 7 Color Bar (MSPG-
925FS model:3, pattern:65) signal into RGB. (using
D-sub to D-sub cable)
2) Set the PSM to Dynamic mode in Picture menu.
3) Press the IN-START key on R/C for adjustment.
4) Press the G (Vol.+) key operate To set , then it
becomes automatically.
5) Auto-RGB OK means adjustment is completed
- 13 -
[Fig.1]
[Fig.3]
Advertisement
