Install Oven - Thermador DM302ES Installation Instructions Manual

5. Install Oven

1. Slide oven into cabinet cutout.
2. Push straight in until oven trim is flush with cabinet
wall, being careful not to crimp flexible conduit
between oven and cabinet back wall. The oven
should be straight and level, not crooked.
3. Install 2 screws through tap holes in trim.
4. Install Base Trim:
Slide base trim over brackets below oven door (See
Figure 6).
Install 2 screws (one on each side) through screw
holes in trim and brackets.
5. Replace Oven Door(s).
6. Test Operation
1. Turn on power at the breaker.
2. Check power at junction box using a volt meter.
For 240 V installation, the reading between the red
and black wires (line to line) should be 220 to 240
volts.
For 208 V installation, the reading between the red
and black wires (line to line) should be 190 to 208
volts.
3. Test the oven mode.
Select the BAKE mode. See the Use and Care
Manual for detailed operation instructions.
4. Verify that the oven light comes on and the oven
begins to preheat.
5. Test the door lock.
Set the SELF CLEAN mode. Confirm that the door
locks when the lock icon appears in the display.
6. If installing a double oven, test the second oven as
well.
7. If any of the tests do not result as explained above,
contact Thermador service for assistance. Other
wise, the installation is complete at this time.
 • English
Step 5 and 6: Install Oven and Test Operation
Figure 6: Installing Base Trim