Samsung SCS26UC4 User Manual
Samsung SCS26UC4 User Manual

Samsung SCS26UC4 User Manual

Wireless network extender
Hide thumbs Also See for SCS26UC4:

Advertisement

Quick Links

Advertisement

Table of Contents
loading

Summary of Contents for Samsung SCS26UC4

  • Page 2 Verizon Wireless N e t w o r k E x t e n d e r User Manual Please read this manual before operating your device, and keep it for future reference.
  • Page 3 Intellectual Property All Intellectual Property, as defined below, owned by or which is otherwise the property of Samsung or its respective suppliers relating to the SAMSUNG Device, including but not limited to, accessories, parts, or software relating there to (the “base station”), is proprietary to Samsung and protected under federal laws, state laws, and international treaty provisions.
  • Page 4 EP68-00359A Printed in Korea Disclaimer of Warranties; Exclusion of Liability For more information, refer to "Warranty Information" on page 25.
  • Page 5: Table Of Contents

    Table of Contents Section 1: Getting Started ..........2 Section 6: Warranty Information ......... 25 Introduction ........2 Standard Limited Warranty .
  • Page 6: Section 1: Getting Started

    Section 1: Getting Started Introduction It is important that you read each section and note any special requirements. However, if you’d like to get right to a specific Congratulations on the purchase of your Verizon Wireless feature, simply locate that section in the Table of Contents and go Network Extender.
  • Page 7: System Requirements

    System Requirements Place the base station near a window in a central location. An always-on broadband Internet connection with a minimum speed of • • For best results, place the base station in an elevated location, such 300 kbps. as the top of a bookshelf or tall cabinet. An available Ethernet port on either your broadband modem or a router •...
  • Page 8 Plug the power supply connector into the DC 12V power port located at the rear of the base station (3). Insert one end of the power cord into the power supply and then plug the other end into an available power outlet (4).
  • Page 9 Confirm that the front LEDs are illuminated as indicated • WAN LED: should be a steady blue light, indicating that the base station has detected a valid Ethernet connection. A blinking blue below: LED indicates data communication. • Power LED: should be a continuous blue light, indicating Note: Allow 3 - 5 minutes for the base station to complete the startup that the base station is...
  • Page 10: Section 2: Using Your Device

    Section 2: Using Your Device Additional Setup Information About the size of a traditional wireless access point (WAP), the base station facilitates the delivery of cellular traffic through the Getting started with your new Verizon Wireless Network Extender Internet to the Verizon Wireless network, which then routes the is easy.
  • Page 11 – If a handoff to the nearest compatible cell tower is not possible and all The table below outlines bandwidth requirements based on the channels are not in use, one channel may be available for an number of active callers: unauthorized user to access.
  • Page 12: Activating Your Verizon Wireless Network Extender

    The external GPS antenna (provided with your Verizon Wireless Should you need to activate your base station, you will be asked • Network Extender) allows you to place the Verizon Wireless Network to provide the following information: Extender further from a window and run the antenna to an area with Primary Wireless Phone Number or Verizon Wireless Account Number •...
  • Page 13: Verizon Wireless Network Extender Basics

    Verizon Wireless Network Extender Basics Note: If the unit’s GPS signal strength is weak (due to location), it is Components (page 9) • recommended that you either move the base station near a window or install the external GPS antenna. For more details, see "External GPS Features (page 12) •...
  • Page 14: Components - Rear View

    Components - Rear View The rear of the base station provides access to the WAN port, Function Description power port, and external GPS antenna. Power Solid blue: normal • GPS Antenna Port slides to provide access to the external No light: abnormal •...
  • Page 15 WAN Port allows you to connect the Ethernet cable provided to establish communication between the base station and your broadband router. This connection port is then used to transmit voice and data through the Internet GPS Antenna Port to the Verizon Wireless network, which then authenticates the base station and allows communication with wireless phones.
  • Page 16: Features

    Features Maintenance Notes The following list highlights some of the base station's features: These notes should be carefully reviewed before using the base station: The base station enables users to easily install and configure the • system by connecting to an existing broadband network. See “General Precautions”...
  • Page 17: Section 3: External Gps Antenna

    Section 3: External GPS Antenna If your Verizon Wireless Network Extender cannot receive a When positioning the GPS antenna, ensure that it is: Global Positioning System (GPS) signal, it may be necessary to Installed in a horizontal position. • improve the reception by installing and then positioning the Adjacent to a window and in an open area.
  • Page 18 Connect and secure the GPS antenna to the end of the provided GPS cable labeled "Connect to GPS Antenna." GPS antenna Connect and secure the terminal end of the same cover mini-coax cable to the port on the base station (within the GPS antenna compartment).
  • Page 19 Note: If a GPS signal cannot be detected, remove the GPS antenna and place it in a new location to receive a stronger signal. This new location should be located close to a window. Mini-coax connector GPS antenna compartment Power on the base station to allow the detection of both the external antenna connection and an available GPS signal.
  • Page 20: Section 4: Troubleshooting

    Section 4: Troubleshooting Now that you’ve been given an overview of the Verizon Wireless – If the preceding fails, remove the power cord from the wall outlet for at Network Extender base station, some situations might arise least 10 seconds. where you’ll need additional usage or connection help.
  • Page 21 My System LED is solid red. The Network Extender base station seems to be getting too hot. • • – A red System LED indicates a system error was detected and is – Make sure there is nothing blocking the heat vents located along the symptomatic of a communication problem with the Verizon Wireless side of the base station.
  • Page 22 unauthorized user to access. Callers on the managed access list are Note: Both authorized and unauthorized callers may see more service bars always given priority access to the Network Extender. on their Verizon Wireless handset due to their proximity to the Verizon Wireless Network Extender.
  • Page 23: Section 5: Important Safety Information

    Section 5: Important Safety Information This user guide contains important operational and safety Do not attempt to open the base station or power supply, or dissemble • information that will help you safely use your base station. either component, or remove the wireless antenna. You run the risk of General Precautions electrical shock and/or burn and voiding the limited warranty.
  • Page 24: Using Your Base Station Near Other Electronic Devices

    Using Your Base Station Near Other Electronic Knowing Radio Frequency Safety Devices The design of your base station complies with updated NCRP standards described below: Most modern electronic equipment is shielded from radio frequency (RF) signals. However, RF signals from your base In 1991–92, the Institute of Electrical and Electronics Engineers station may affect inadequately shielded electronic equipment.
  • Page 25: Fcc Radio Frequency Emission

    FCC Radio Frequency Emission This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not This device meets the FCC Radio Frequency Emission Guidelines. cause harmful interference, and (2) This device must accept any FCC ID number: A3LSCS-26UC4.
  • Page 26 Please read the following important safety notices and Never push objects of any kind into this product through instructions before installing or using the product. cabinet slots as they may touch dangerous voltage points A DANGER warning refers to situations that could cause bodily injury. •...
  • Page 27 To avoid electric shock, do not operate the product or connect or d. If the product does not operate normally when the operating disconnect cables during electrical storms. To avoid electric instructions are followed. Adjust only those controls that shock, do not use this product in or near water. are covered by the operating instructions, since improper adjustment of other controls may result in damage and will To reduce the risk of fire or overheating, keep this product in well...
  • Page 28: User Guide Proprietary Notice

    User Guide Proprietary Notice CDMA Technology is licensed by QUALCOMM Incorporated under one or more of the following patents: 4,901,307 5,109,390 5,267,262 5,416,797 5,506,865 5,544,196 5,657,420 5,101,501 5,267,261 5,414,796 5,504,773 5,535,239 5,600,754 5,778,338 5,228,054 5,337,338 5,710,784 5,056,109 5,568,483 5,659,569 5,490,165 5,511,073 Important Safety Information...
  • Page 29: Section 6: Warranty Information

    (d) malfunctions resulting from the use of Product in conjunction with accessories, products, or ancillary/peripheral What is Covered and For How Long? equipment not furnished or approved by SAMSUNG; (e) defects or SAMSUNG TELECOMMUNICATIONS AMERICA, LLC ("SAMSUNG") damage from improper testing, operation, maintenance, warrants to the original purchaser (“Purchaser”) that SAMSUNG’s...
  • Page 30 THE ABOVE LIMITATION MAY NOT APPLY TO YOU. IN ADDITION, EXCEPT AS SET FORTH IN THE EXPRESS WARRANTY CONTAINED SAMSUNG SHALL NOT BE LIABLE FOR ANY DAMAGES OF ANY HEREIN, PURCHASER TAKES THE PRODUCT "AS IS," AND KIND RESULTING FROM THE PURCHASE, USE, OR MISUSE OF, OR...
  • Page 31 Limited Warranty. The agents, employees, UNENFORCEABLE BY REASON OF ANY LAW, SUCH PARTIAL distributors, and dealers of SAMSUNG are not authorized to make ILLEGALITY OR UNENFORCEABILITY SHALL NOT AFFECT THE modifications to this Limited Warranty, or make additional ENFORCEABILITY FOR THE REMAINDER OF THIS LIMITED warranties binding on SAMSUNG.
  • Page 32 Customer Care Center: Phone: 1-888-987-HELP (4357) © 1000 Klein Rd. 2008 Samsung Telecommunications America. All rights reserved. Plano, TX 75074 No reproduction in whole or in part allowed without prior written Toll Free Tel: 1.888.987.HELP (4357) approval. Specifications and availability subject to change Samsung Telecommunications America, LLC: without notice.
  • Page 33: Index

    Index Activation Understanding Your Device Antenna Power Warranty Information System Components Front View Rear View Maintenance Notes E911 Network Extender Basics Getting Started Features Activating Your Device Front View GPS Antenna Rear View Installation Mini-coax Connector Port Port DC 12V Power GPS Antenna Heat Vents Standard Limited Warranty...

Table of Contents