Daily Use - Washing & Drying - Electrolux EW7W4316DB User Manual

Table of Contents

Advertisement

• 5 minutes after the end of the washing
programme.
Press the Marche/Arrêt button to
activate the appliance again.
The display shows the end of the last
programme.
Turn the programme dial to set a new
cycle.
If the dial is rotated to the "Reset"
position
turns off in 30 seconds.
13. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
13.1 Complete wash&dry
programme
Automatic Non-Stop
programme or programmes
Depending on the model, the appliance
may be equipped with one or more
Propre & sec programmes, automatic
one-go programmes where it is not
necessary to set the Mode - Séchage.
Proceed as follows:
1. After loading laundry and detergent,
press the Marche/Arrêt button for
some seconds to activate the
appliance.
2. Set the Propre & sec programme by
means of the programme dial. The
indicators
display.
3. Touch the Départ/Pause
to start the programme.
Non-automatic wash&dry
programmes
In some washing programmes, you can
combine Mode - Lavage and Mode -
Séchage for running a complete
wash&dry programme.
, the appliance automatically
and
appear on the
Proceed as follows:
1. After loading laundry and detergent,
press the Marche/Arrêt button for
some seconds to activate the
appliance.
2. Load the laundry one item at a time.
3. Put the detergent and the additives in
the appropriate compartment.
4. Turn the programme dial to the
washing programme. The appliance
defaults to the washing only mode
and the indicator of the Mode -
Lavage button is on. The display
shows the default temperature and
spin. If necessary, change them
according to your laundry. The
display also shows the maximum
recommended load for washing
phase.
5. Set the desired options, if there are
available.
6. Tap on the Mode - Séchage button to
activate also the drying function. Both
indicators of the Mode - Lavage and
Mode - Séchage buttons are on. The
indicators
display. The display also shows the
maximum recommended load for a
washing and drying programme (e.g.
button
6 kg for cottons).
13.2 Washing and Drying -
Automatic levels
1. Tap on the Niveau séchage button
repeatedly until the display shows the
required dryness level. The indicators
in the display illuminate accordingly:
a.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
and
appear on the
Iron dry: for cotton items;
ENGLISH
33

Advertisement

Table of Contents
loading

Table of Contents