Table of Contents
Advertisement
Clear RTC RAM (2-pin CLRTC)
This header allows you to clear the CMOS RTC RAM data of
the system setup information such as date, time, and system
passwords.
To erase the RTC RAM:
1.
2.
3.
4.
If the steps above do not help, remove the onboard battery and short the two pins
again to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the
battery.
Intel
®
This jumper allows you to enable or disable the Intel
jumper to pins 1-2 to enable (default) the Intel
disable it.
USB 2.0 connector (10-1 pin USB1314)
Connect the USB module cable to this connector, then install the module to a slot
opening at the back of the system chassis. This USB connector complies with
USB 2.0 specifications and supports up to 480Mbps connection speed.
LAN LED connectors (4-pin LANLED1, 4-pin LANLED2)
These connectors are for Gigabit LAN activity LEDs on the
front panel. Connect the LAN LED cable to the backplane
for LAN activity indication.
LPT connector (26-1 pin LPT)
Connect a parrallel port device such as a printer to this LPT (Line Printing
Terminal) connector.
Mono out header (2-pin MONO_OUT)
This internal mono out header allows connection to an internal, low power
speaker for basic system sound capability. The subsystem is capable of driving a
speaker load of 4 Ohms at 2 Watts (rms).
1-4
Turn OFF the computer and unplug the power cord.
Use a metal object such as a screwdriver to short the two
pins.
Plug the power cord and turn ON the computer.
Hold down the <Del> key during the boot process and enter
BIOS setup to re-enter data.
ME jumper (3-pin DIS_ME)
ME function. Set this
®
ME function and to pins 2-3 to
®
Chapter 1: Product introduction
CLRTC
PIN 1
Advertisement
Table of Contents
