Table of Contents
Advertisement
Remove the system board
Make sure the following FRUs (or CRUs) have been removed.
"Remove the deco cover" on page 30
"Remove the lower case" on page 31
"Remove the battery pack" on page 32
"Remove the solid-state drive (SSD) (on selected models)" on page 33
"Remove the solid-state drive (SSD) (on selected models)" on page 34
"Remove the thermal module" on page 34
"Remove the Wi-Fi card" on page 35
"Remove the DC-in bracket" on page 36
"Remove the memory module" on page 38
Step 1.
Remove the tape then disconnect the EDP cable connector.
Figure 22. Disconnect the EDP cable connector
Step 2.
Disconnect cables connected to the system board.
42
Hardware Maintenance Manual
Advertisement
Table of Contents
