Electrical Connections - Electrolux EHG7822X Instruction Booklet

20 electrolux

Electrical Connections

Electrical Connections
Electrical Connections Electrical Connections Electrical Connections
Any electrical work required to install this hob should be Any electrical work required to install this hob should be
Any electrical work required to install this hob should be Any electrical work required to install this hob should be Any electrical work required to install this hob should be
carried out by a qualified electrician or competent person, carried out by a qualified electrician or competent person, carried out by a qualified electrician or competent person,
carried out by a qualified electrician or competent person, carried out by a qualified electrician or competent person,
in accordance with the current regulations. in accordance with the current regulations. in accordance with the current regulations.
in accordance with the current regulations. in accordance with the current regulations.
THIS HOB MUST BE EARTHED. THIS HOB MUST BE EARTHED. THIS HOB MUST BE EARTHED. THIS HOB MUST BE EARTHED. THIS HOB MUST BE EARTHED.
Electrical Requirements Electrical Requirements
Electrical Requirements Electrical Requirements Electrical Requirements
Any permanent electrical installation must comply with the latest I.E.E.
Regulations and local Electricity Board regulations. For your own safety
this should be undertaken by a qualified electrician, e.g. your local Electricity
Board, or a contractor who is on the roll of the National Inspection Council
for Electrical Installation Contracting (NICEIC).
The manufacturer declines any liability should these safety measures not
be observed.
This hob is designed to be connected to a 230 V 50 Hz AC electrical supply.
Before switching on, make sure the electricity supply voltage is the same
as that indicated on the hob rating plate. The rating plate is located on the
bottom of the hob. A copy is attached on the back cover of this book.
The hob is supplied with a 3 core flexible
supply cord incorporating a 3 amp plug
fitted. In the event of having to change the
fuse, a 3 amp ASTA approved (BS 1362)
fuse must be used.
Should the plug need to be replaced for any
reason, the wires in the mains lead are
coloured in accordance with the following
code:
Green and Yellow
Blue
Brown
1) Connect the green and yellow (earth) wire to the terminal in the
plug which is marked with the letter 'E' or the earth symbol
or coloured green and yellow.
2) Connect the blue (neutral) wire to the terminal in the plug which
is marked with the letter 'N' or coloured black.
3) Connect the brown (live) wire to the terminal in the plug which
is marked with the letter 'L' or coloured red.
- Earth
- Neutral
- Live
FO 0390