Table of Contents
Advertisement
18
www.aeg.com
7.4 Introduction
The options/functions are
not selectable with all
washing programmes.
Check the compatibility
between options/functions
and washing programmes in
the "Programme Chart". An
option/function can exclude
another one, in this case the
appliance doesn't allow you
to set the incompatible
options/functions together.
Make sure the screen and
touch buttons are always
clean and dry.
7.5 AutoDose Liquid
Detergent
Softener
By means of this buttons you can:
•
: activate and deactivate the
automatic detergent loading.
•
: activate and deactivate the
automatic fabric softener loading.
Refer to "The AutoDose
Technology (Autodosing)"
chapter for more details.
7.6 Remote start
A quick touch of this button activates the
Remote Start function that allows you to
start, pause and stop the appliance
remotely.
The related led comes on and the related
icon appears on display.
If you set a programme via
App and it does not match
with the knob position,
text appears alternating with
programme duration.
Press and hold this button for longer time
to provide two other functions:
• hold it down for 3 seconds as long as
a click sounds: the Wi-Fi is turned on
and off.
• hold it down for 10 seconds as long
as a double beep sounds and
and Fabric
appears on the display: to reset the
Network Credentials.
7.7 Finish In
Set this option as last after
programme and other
options selection, otherwise
it can be cancelled if you
change some setting.
This option allows choosing the time
within which a programme should
terminate. The programme end can be
postponed by one 1 hour every button
touch until 24 hours maximum.
The display shows the normal
programme duration alternatively with
the set programme end time (expressed
in hours 0h). The minimum selectable
time corresponds to rounded up hour of
the maximum duration of a programme
(e.g. if the cycle duration lasts 3:15
hours, the minimum selectable time will
be 4h).
After programme start, the door is locked
and the appliance starts the ProSense
phase. When load estimation ends, on
the display the icon of running phase
blinks and the time digit counts down in
steps of one hour and in steps of 1
minute during the last hour.
7.8 Start/Pause
Touch the Start/Pause
start, pause the appliance or interrupt a
running programme.
7.9 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric
creasing and facilitates the fabric ironing.
The Plus Steam option achieves good
results with a small load because steam
better penetrates the laundry if there is
more space. For this reason, the
programme maximum load combined
with this option is 2 kg (approximately 8 -
10 shirts).
button to
Advertisement
Table of Contents
