Samsung S32B806PXN Instruction Manual page 33

2nd 3rd
Auto Source Switch+ Auto Source Switch+
USB-C Switch
Key Repeat Time
Power LED On
USB-C Preference
Setup Custom Key
Eco Sensor Mode
Max. Power Saving
Description
When there is no signal, the display automatically switches to the newly connected device.
― This function may not be supported depending on the model or geographical area.
When there is no signal, the display automatically switches to the new device connected to the USB-C port.
Control the response rate of a button when the button is pressed.
Acceleration, 1 sec or 2 sec can be selected. If
Configure the settings to enable or disable the power LED located at the lower part of the product.
• Working: The power LED is on when the product is turned on.
• Stand-by: The power LED is on when the product is turned off.
Choose between high resolution and data transfer speed. If you change the settings during data transfer, the transfer may be canceled or data
corruption may occur.
• High Resolution: If High Resolution is selected, 3840 x 2160 @ 60 Hz is available for input of USB-C. The performance for
limited. The port operates as USB 2.0.
• High-Speed Data: If High-Speed Data
Set the custom key so that your chosen function can be set up directly.
Optimizes brightness in real time, based on your lighting environment.
Set to on, Ethernet is turned off to save power. Set to off, the USB-C connected PC or laptop can be woken by LAN.
No Repeat is selected, a command responds only once when a button is pressed.
is selected, 3840 x 2160 @ 60 Hz is not available for input of USB-C. The
ports may be
port operates as USB 3.0.
33