Advertisement
Quick Links
Unpacking and Installing
If you unpack a LivingColors, the product is already linked to the remote control. You only need to plug it into the power system,
put the batteries into the remote control and start the experience!
=
Step 1:
Place your LivingColors in a selected location on a flat and stable surface and direct it towards the wall
(the optimal distance is 50 cm).
Step 2:
Plug your LivingColors into the power system.
Step 3:
Insert the two AAA-batteries by sliding open the battery compartment (+ and – as indicated) on the back
of the remote control.
Questo manuale d'istruzione è fornito da trovaprezzi.it. Scopri tutte le offerte per
PH lampada da tavolo LEDbianco
User Manual LivingColors Bloom
Getting started with your LivingColors
+
o cerca il tuo prodotto tra le
+
Philips Bloom 70997/60/
migliori offerte di Illuminazione per Interni
+
Advertisement
Related Manuals for Philips LivingColors Bloom 70997/60/PH
Summary of Contents for Philips LivingColors Bloom 70997/60/PH
- Page 1 Questo manuale d’istruzione è fornito da trovaprezzi.it. Scopri tutte le offerte per Philips Bloom 70997/60/ PH lampada da tavolo LEDbianco o cerca il tuo prodotto tra le migliori offerte di Illuminazione per Interni User Manual LivingColors Bloom Getting started with your LivingColors Unpacking and Installing If you unpack a LivingColors, the product is already linked to the remote control.
-
Page 2: Basic Functionality
Basic functionality Switch the LivingColors “On” or “Off”: Your LivingColors can be switched “On” and “Off ” by using the “I”- and “0”-button on the remote control. If you switch the LivingColors “Off ”, it will remember your last setting for the next time you use it. Colour selection: To let your LivingColors change to whatever colour you like, simply rotate the colour wheel (rotary wheel at the centre of the remote control) until you have found the right colour. -
Page 3: Extended Functionality
Colour intensity (saturation): If you want to add more white to your current colour or make your colour intense (saturated) again, you can easily change the colour intensity (saturation). Just press the colour wheel on the left (more white) or right (more colour) position. If you keep pressing on the left position, you will ultimately reach white. - Page 4 Hold the remote control close against the Philips logo on the lens of the product, then press and hold the “I” button. The product will flash 3 times. Hold the “I”-button until the LivingColors displays a green light. It is now connected to the remote control.
- Page 5 - see further). Alternatively, you can disconnect a remote control from a luminaire as follows: Hold the remote control against the Philips logo on the lens of the product, then press and hold the “0”-button. The product will flash 3 times. Hold the “0”-button until the LivingColors is switched off automatically.
- Page 6 Step 3: You still need to connect the additional remote to the LivingColors. If you have two round remotes, you can do it easily by re- peating the above action (bring two remotes close, then press on “I” until they stop blinking intermittently). This action needs to be done directly after connection of the additional remote control.
- Page 7 Solution 3: Reset the remote control Open the remote control’s battery compartment and press the RESET button for a few seconds (e.g. with a paper clip). Make sure that the batteries are in. After this action, you need to reconnect your LivingColors to the remote control.