Air King Exhaust Fan with Light AKLC701 Operating Manual

Air King Exhaust Fan with Light AKLC701 Operating Manual

Air king exhaust fan with light important instructions operating manual
Hide thumbs Also See for Exhaust Fan with Light AKLC701:
Table of Contents
  • Français

    • Read and Save These Instructions
    • General Safety Information
    • Installation Instructions
    • Figure 10
    • Make Sure Power Is Switched off at
      • Limited Warranty
    • Figure 1

Advertisement

Available languages

Available languages

Quick Links

IMPORTANT INSTRUCTIONS -
: AKLC701, AKLC702,
Models
AKLC703, AKLC709

READ AND SAVE THESE INSTRUCTIONS

READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT
YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
electric shock and injury to person, including the following:
1. Read all instructions before installing or using exhaust fan.
2. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer.
3. Before servicing or cleaning the unit, switch power off at
service panel and lock the service disconnecting means to
prevent power from being switched on accidentally. When
the service disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to the
service panel.
4. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable codes
and standards, including fire-related construction.
5. Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA)
and the American Society for Heating, Refrigeration, and Air
Conditioning Engineers (ASHRAE), and the local code authorities.
CAUTION:
FOR GENERAL VENTILATING USE ONLY. DO
NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS
AND VAPORS.
210572200 Rev. A 6-06
OPERATING MANUAL

GENERAL SAFETY INFORMATION

When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
SAVE THESE INSTRUCTIONS
6. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. This unit must be grounded.
9. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off
power unit.
WARNING:
DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL
DEVICE.
WARNING:
A SHOWER STALL ENCLOSURE.
10. NEVER place a switch where it can be reached from a tub or
shower.
WARNING:
www.airkinglimited.com
Exhaust Fan with Light
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
DO NOT INSTALL OVER A TUB OR MOUNT IN
DO NOT USE IN KITCHENS
1 of 12

Advertisement

Table of Contents
loading

Summary of Contents for Air King Exhaust Fan with Light AKLC701

  • Page 1: Read And Save These Instructions

    IMPORTANT INSTRUCTIONS - OPERATING MANUAL : AKLC701, AKLC702, Models AKLC703, AKLC709 READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
  • Page 2: Installation Instructions

    INSTALLATION INSTRUCTIONS CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE STARTING INSTALLATION. SECTION 1 Preparing the Exhaust Fan 1. Unpack fan from the carton and confirm that all pieces are present. In addition to the exhaust fan you should have: 1 - Grill with Glass Light Lens 1 - Damper Assembly (attached) 2 - #8 Screws...
  • Page 3 SECTION 4 Ducting CAUTION: ALL DUCTING MUST COMPLY WITH LOCAL AND NATIONAL BUILDING CODES. 1. Connect the ducting to the fan’s duct collar (Figure 5). Secure in place using tape or screw clamp. Always duct the fan to the outside through a wall or roof cap. Figure 5 NOTE: If damper detaches from unit, reattach by snapping the collar back onto the unit.
  • Page 4: Figure 10

    the wall switch to both the red wire from the fan’s light receptacle and the black wire from the fan’s exhaust receptacle. Connect the ground wire from the house to the green wire from the fan’s grounding screw (Figure 10). Use approved methods for all connections.
  • Page 5: Limited Warranty

    Air King will not be held responsible for any bodily injury or damages to personal property or real estate whether caused directly or indirectly by the product. Some states and provinces do not allow the exclusion or limitation of incidental or consequential damages and some states do not allow limitations on how long an implied warranty lasts, so these exclusions or limitations may not apply to you.
  • Page 6: Www.airkinglimited.com

    REPLACEMENT PARTS DIAGRAM Qty. Description Fan Housing Mounting Rails Collar/Damper External Wire Cover Gasket - Collar Interior Wire Cover #8 B Screw #6 B Screw Polarized Connector Receptacle Motor Motor Mounting Screw Blower Wheel Cap Screw Blower Housing 210572200 Rev. A 6-06 Replacement Part # 5S1234001 5S1299002...
  • Page 7 INSTRUCTIONS IMPORTANTES – MANUEL D’OPÉRATION : AKLC701, AKLC702, Modèles AKLC703, AKLC709 LIRE ET CONSERVER CES INSTRUCTIONS LIRE SOIGNEUSEMENT AVANT DE TENTER D’ASSEMBLER, INSTALLER, OPÉRER OU DE RÉPARER LE PRODUIT DÉCRIT. PROTÉGEZ VOUS-MÊME ET LES AUTRES EN OBSERVANT TOUTE L’INFORMATION DE SÉCURITÉ. FAILLIR À SE CONFORMER AUX INSTRUCTIONS PEUT RÉSULTER EN BLESSURE PERSONNELLE GRAVE ET/OU EN DOMMAGE À...
  • Page 8: Figure 1

    INSTRUCTIONS D’INSTALLATION AVERTISSEMENT: VOUS ASSURER QUE L’ALIMENTATION EST COUPÉE AU PANNEAU DE SERVICE AVANT DE COMMENCER L’INSTALLATION. SECTION 1 Préparation du Ventilateur d’évacuation 1. Sortir le ventilateur de sa boite et confirmer que toutes les pièces sont présentes. En plus du ventilateur d’évacuation vous devriez avoir: 1 - Grille avec les Lentilles de l’éclairage 1 - Ensemble de clapet (attaché)
  • Page 9 SECTION 4 Conduits AVERTISSEMENT: TOUS LES CONDUITS DOIVENT ÊTRE CONFORMES AUX CODES DU BÂTIMENT LOCAUX ET NATIONAUX. 1. Raccorder le conduit au collet de conduit du ventilateur (Figure 5). Fixer en place à l’aide de ruban ou de serre-joint. Toujours évacuer le ventilateur vers l’extérieur au travers de chapeau mural ou de toit.
  • Page 10 deux fils blancs du réceptacle de la lumière et le fil blanc du réceptacle du ventilateur d’évacuation. Raccorder le fil noir provenant du commutateur mural aux deux fils rouge du réceptacle de la lumière et au fil noir du réceptacle du ventilateur d’évacuation. Raccorder le fil de mise à...
  • Page 11 3b. L’hélice du ventilateur frotte contre le cabinet de l’unité. Tous les produits fabriqués par Air King Limited sont garantis pour un an à partir de la date d’achat contre les défauts de main d’œuvre et/ou de matériel. De plus, tous les ventilateurs / évacuateurs, chaufferettes, combinés ventilateur/ lumière et/ou les chaufferettes et les hottes de cuisine sont garantis pour cinq années à...
  • Page 12 DIAGRAMME DES PIÈCES DE REMPLACEMENT Qté. Description Cabinet du ventilateur Traverses de Montage Collet / Clapet Couvercle de Câble Externe Joint – Collet Couvercle de Câble Interne Vis #8 de B Vis #6 de B Polarized Connector Réceptacle Moteur Vis de Montage de Moteur Roue de la Soufflante Vis du Capuchon Cabinet de la Soufflante...

This manual is also suitable for:

Aklc702Aklc703Aklc709

Table of Contents