Advertisement
1.
User must determine potential hazard relating to age of paint to be removed. (Modern paints do not contain lead).
2.
DANGER! Keep all persons and pets away from the work area. The following are particularly vulnerable to the effects of lead paint dust:
Expectant women, babies and children.
3.
We recommend personal protection by using the following safety items:
a) Paint Spray Respirator.
b) PE Coated Hooded Coverall.
c) Latex Gloves.
4.
Take adequate measures to contain the paint dust, flakes, and scrapings.
5.
Continue to wear safety equipment as in 3 above, and thoroughly clean all areas when task is complete. Ensure that paint waste is
disposed of, in sealed bags or containers, according to local authority regulations.
2. INTRODUCTION
Brush-less motor adjusts to the pressure applied maintaining a constant speed ensuring consistent sanding. The well-balanced
motor has very low vibration levels creating less user fatigue. Seven selectable speeds from 4,000-10,000rpm in 1,000rpm increments.
LED digital display. 80 x 133mm Backing pad with 3mm orbit. Fitted with a dust extraction port and Supplied with 1m dust extraction
hose, 2 x hose adaptors, 3mm hex key and 6 x sanding sheets (grits - P80, P100, P120, P150, P180, P240).
3. CONTENTS
CONTENTS
1
DAS151PS Sander
2
1m Dust extraction hose
3
Sanding Pads x 6 (Grits P80, P100, P120, P150,
P180, P240).
4
Adaptor (A)
5
Adaptor (B)
3mm Hex key (Not shown on fig.1.)
4. SPECIFICATION
Model No: ...................................................... DAS151PS
Fuse Rating: ............................................................... 13A
Motor Power: ........................................................... 350W
Noise Power/Pressure: ................................... 90/80dB(A)
No-Load Speed: ...................................... 4000-10000rpm
Orbit Size: ...............................................................Ø3mm
Pad Size: .......................................................80 x 133mm
Plug Type:........................................................... 3-Pin BS
Power Supply Cable Length: ........................................2m
Supply: ...........................................................230V~50Hz
Vibration/Uncertainty: ...........................3.221m/s²/1.5m/s²
5. OPERATION
WARNING! Before use, ensure that you have read and understood Section 1 Safety Instructions.
‰
NOTE: The sander is designed for dry use only.
DO NOT use with water or any other liquids.
8
5.1.
The sander is intended to be operated as a hand held tool. The tool can be used in any position without affecting performance.
NOTE: The sander can develop a torque reaction when started.
5.2.
Make sure the sander is switched off. Select a suitable abrasive pad and secure it to the backing pad. Make sure the abrasive is
centred on the sanding pad. For optimal performance we recommend original Sealey sanding pads.
5.3.
Switch on the sander by pressing the On/Off key (see fig.2),
5.4.
The speed can be adjusted between 4,000 and 10000 rpm by rpm + and rpm -. Each press increases or reduces the speed by
1,000 rpm until it reaches its limits. (see fig.2)
5.5.
When sanding, always place the sander on the work surface before starting the tool. Always remove the sander from the work surface
before stopping it. This will prevent gouging of the work surface due to excess speed of the abrasive.
5.6.
When sanding is finished, turn off the sander by pressing the On/Off key.
Speed adjustment +/-
On/Off Switch
© Jack Sealey Limited
3
fig.1
fig.2
Original Language Version
1
4
5
DAS151PS
2
Issue:1
28/06/23
Advertisement
