Craftsman LAWNSWEEPER 486.242211 Owner's Manual page 6

STEP 3: (SEE FIGURE 3)
• Attach the brush assembly with the black brush
retainer to the left end of the brush shaft using two
1/4" x 1" hex bolts (G) and 1/4" nylock nuts (I). The
brush retainer marked with black ink must be placed
to the middle of the sweeper.
• Turn a wheel to rotate the brushes. (The wheels drive
the brushes in one direction only.) The overlap bristles
should be on the back side of the brush as it rotates.
BRUSH RETAINER
MARKED BLACK
FIGURE 3
1/4" x 1"
HEX BOLT (G)
1/4" NYLOCK NUT (I)
STEP 4: (SEE FIGURE 4)
• Cut off the plastic tie that holds the height adjustment
tube in place.
• Assemble the R.H. hitch tube to the sweeper housing
using two 5/16" x 1-1/2" carriage bolts (C), and two
5/16" nylock nuts (J). Do not tighten yet. Repeat for
the L.H. hitch tube.
5/16" NYLOCK NUT (J)
5/16" x 1-1/2"
CARRIAGE BOLT (C)
FIGURE 4
STEP 5: (SEE FIGURE 5)
• Fasten the hitch tubes together using two 5/16" x
2-1/2" hex bolts (A) and 5/16" nylock nuts (J). Do not
tighten yet.
5/16" x 2-1/2"
HEX BOLT (A)
FIGURE 5
6
5/16"
NYLOCK NUT (J)