Buss assignment
Busses 1-8 can now be assigned to the stereo buss on
the
page, the
ASSIGN
MODULE
section key.
ASSIGN
Bear in mind that like
EFFECT 1-2
ASSN RETURNS 1-4
, these signals enter the stereo buss
after (post) the Master Comp Insert Matrix.
The result of this is that if you are compressing the
stereo buss, these signals assigned to the stereo buss
are not affected by the compressor.
However, if the
ASSIGNABLE
used as stereo buss
INSERTS
the signals sent to the stereo buss. Any analog inserts
used on the stereo buss will also affect these signals.
1
To assign these signals directly to the stereo
buss, use POD 4 to move the cursor to
the upper right of the
2
Then use the
key of the buss, or the cur-
SEL
sor keys or the dial to highlight the item you
wish to assign and press the
This assignment can also be made in the buss
MODULE
page.
To assign busses 1-8 to the stereo buss using the
STEREO
key in assign section:
1
Select the busses 1-8 using the
2
Then press the
STEREO
tion. Busses 1-8 are assigned to the stereo
buss directly (this can be confirmed on the
MODULE
page).
New features in DM-24 version 2.1
page and also using the
,
and
DIGITAL IN 1-2
sends and returns are
, these inserts will affect
in
ST
ASSIGN
page.
ENTER
key.
SEL
keys.
key in the assign sec-
Buss signals assigned to the stereo buss fol-
low the
Balance Level CENTER: 0dB
OPTION-PREFERENCES
page.
TASCAM DM-24 Version 2.1 Release Notes
9101449300
setting on the
1