Application Note - TRENDnet TU2-ET200 User Manual

TU2-ET200 User's Guide
4 . Run Un20DOCK.exe from the driver folder in USB 2.0 Mobile Docking Station
CD.
5. Please Press "OK" to remove Serial Converter. (
Fig.18
6. Press "Yes" to reboot your Windows system to complete procedure. (
Fig
.19)
Fig.19
March 11, 2004
Ref. to Fig
.18)
Ref. to
33
TU2-ET200 User's Guide

4. APPLICATION NOTE

1. USB 2.0 Mobile Docking Station normally derives its own power from PC
Host. When only the Host power is supplied, the Power LED will turn RED,
and the serial, parallel, keyboard, mouse, Ethernet and 3 downstream ports
can operate without the external power adapter.
2. Please note that if the external power adaptor is not used and heavy power
consumption USB device is connected, the 3 downstream ports may not
function normally. Therefore the use of the external power adaptor is highly
recommended. You may use the external power by connecting an external 5
voltage, 2A DC power that is UL, CE, T-mark or locally approved. For
Polarity, see the following:
3. Unknown Device:
If the installation process is completed and some of the devices still don't
work, please click on Start, Settings, Control Panel, double-click System,
and Device Manager. Check "Human Interface Devices", "Keyboard",
"Mouse", "Network adapters", "Ports", and "Universal serial bus controller"
on the dialog box and see if "Unknown device" appears on the screen. You
Unknown device
need to right-click the "
it. Then choose Refresh to re-detect the device. (You might need to install
the device driver once again so please follow the same installation
procedures as section 2.1). After trying the above procedures and your device
still does not work, please contact technical support at your local distributor.
March 11, 2004
" and choose Remove to remove
34