Lincoln Electric X-TRACTOR 5A Operator's Manual page 12

X-TRACTOR ® 5A WELDING FUME EXTRACTOR
3. You can now press the left 'off/arrow down' button for
decreasing the time or the right 'on/arrow up' button to increase
the time.
2
4. If the desired ON time is set, then simply don't press any
buttons and after a few seconds the display will start flashing
illustrating that the new time is being saved.
Once the new time is saved, the unit will start operating with the new
time setting.
5. To change the OFF time simply press the left 'off/arrow down'
button and 'off" will appear briefly on the display.
oF
6. You can now press the left 'off/arrow down' button for
decreasing the time or the right 'on/arrow up' button to increase
the time.
2
7. If the desired OFF time is set, then simply don't press any
buttons and after a few seconds the display will start flashing
illustrating that the new time is being saved.
Once the new time is saved, the unit will start operating with the new
time settings.
8. The unit is now fully programmed to your desired time
settings and will work fully automatically.
9. Press the TEST button to check the valve function.
2
10. Your D-LUX timer is ready for operation!
CHANGING THE TIMER FUNCTION
The D-LUX timer is able to perform the following functions:
• Function 'A' start with the ON time and then the OFF time, etc.
• Function 'C' start with the OFF time and then the ON time, etc.
• Function 'B' single shot, starts with the ON time and then switches
OFF indefinite.
• Function 'D' single shot, starts with the OFF time and then switches
ON indefinite.
• Function 'E' start with OFF time then ON time and then switches
OFF indefinite.
• Function 'F' start with ON time then OFF time and then switches
ON indefinite.
The D-LUX timer is factory set to the function 'A'. However, should
you need a different function you can always change it. To do so
please follow these easy steps:
1. Disconnect the unit from the power supply.
2. Press and hold down the (TEST) button.
3. Connect the unit to the power supply.
4. Release the TEST button after 'A' appears on display if the unit is
being programmed for the first time. If the function has already
been changed then the last set function will appear on display (A/
B/ C/ D/ E or F).
5. Use (off/arrow down) and (on/arrow up) to select the function (A/ B/
C/ D/ E or F).
6. When the function is selected do not press anything and after a few
seconds the unit will resume operation with the new function
setting.
7. Change the pre-set ON and/or OFF times if required
12
OPERATION