Table of Contents
Advertisement
23 Programme block/unblock (Command: m d)
►This command may work differently depending on model and
signal.
Transmission
(m)(d)( )([Set ID])( )([Data] 00)( )([Data] 01)( )([Data] 02)([Data] 03)
([Data] 04)(Cr)
([Data] 00) : Physical Channel Number
([Data] 01)([Data] 02) : Channel Data
- ([Data] 01) : High Channel data
- ([Data] 02) : Low Channel data
00 00 ~ 27 0F (Decimal: 0 ~ 9999)
([Data] 03) : Input Source
- 10 : Antenna TV (DTV)
- 20 : Antenna Radio (Radio)
- 40 : Satellite TV (SDTV)
- 50 : Satellite Radio (S-Radio)
- 90 : Cable TV (CADTV)
- a0 : Cable Radio (CA-Radio)
([Data] 04) : block(01) / unblock(00)
Ack
(d)( )([Set ID])( )(OK/NG)([Data] 00])([Data] 01)([Data] 02)([Data] 03)
([Data] 04)(x)
* Block/Unblock Command Examples
Block/Unblock Digital Antenna (DVB-T) Channel 800
([Set ID]) = All = 01
([Data] 00) = Physical Channel Number 30 = 1E
([Data] 01) & ([Data] 02) = Channel Data is 800 = 03 20
([Data] 03) = Digital Antenna TV = 10
([Data] 04) = block/unblock = (01/00)
Result :
md 01 1E 03 20 10 (01/00)
34
24 Fail Over Mode (Command: m i)
►Selects the Fail Over mode.
Transmission
(m)(i)( )([Set ID])( )([Data])(Cr)
[Data] 00 : Off
[Data] 01 : Auto
[Data] 02 : Manual
Ack
(i)( )([Set ID])( )(OK/NG)([Data])(x)
25 Fail Over Input Select (Command: m j)
►Selects an input source for fail over. (This feature is only available
when Fail Over is set to Custom.)
Transmission
(m)(j)( )([Set ID])( )([Data]1)( )([Data]2)( )([Data]3)( )([Data]4)...( )
([Data]N)(Cr)
[Data] 1-N (Input priority 1-N)
[Data] 20 : AV1
[Data] 21 : AV2
[Data] 22 : AV3
[Data] 90: HDMI1
[Data] 91: HDMI2
[Data] 92: HDMI3
[Data] 93: HDMI4
Ack
(j)( )([Set ID])( )(OK/NG)([Data]1)([Data]2)([Data]3)([Data]4)...([Data]
N)(x)
* Some input signals may not be available for all models.
* The data number (N) may vary depending on the model. (The data
number depends on the number of supported input signals.)
Advertisement
Table of Contents
