Programming Channel Memory - Toshiba 21V1R Service Manual

• First, use the ASM (Automatic Search Memory) function to preset all the active channels in your area automatically.
Then, arrange the preset channels with the SEARCH (>>>), MFT (Manual Fine Tuning) and AFT (Auto Fine Tuning)
functions so that you can tune into only desired channels.
• This section shows how to tune in channels using mainly the Remote Controller. You can also perform the system
select, ASM, SEARCH (>>>), SKIP, MFT and AFT operations using the buttons on the TV set.
To preset channels (ASM)
ASM (Automatic Search Memory)
1
Select the head of the position number to start the ASM
with the CH down ( )/up (
select buttons.
2
Press the MENU button repeatedly to call up the SET
UP menu on the screen.
3
Confirm that "COLOR" is set to "AUTO" and "SOUND"
is set to proper system.
If not, press the t/s buttons to move the cursor (-) to
"COLOR" or "SOUND" and press the –/+ buttons to
select each proper system.
4
Press the t/s buttons to move the cursor (-) to
"ASM".
5
Press the "+" button to start the ASM. All active chan-
nels will be stored in the memory automatically.
When programming is complete, the initial position
number will reappear.
After presetting
Check the preset channels by pressing the CH down (
( ) buttons.
• If the picture or sound of a certain channel is not good, fine-
tune the channel using the MFT function.
• If the colour of a certain channel is abnormal, automatic
colour system selection (AUTO) may malfunction, or sound
system selection is wrong. In such a case, select another
colour and/or sound system.

PROGRAMMING CHANNEL MEMORY

) buttons or the digit/direct
)/up
– 15 –
To preset channels
(Manual search, AFT, MFT)
Manual search (>>>)
1
Select a position number with the CH down (
( ) or digit/direct select buttons.
2
Press the MENU button repeatedly to call up the SET
UP menu on the screen.
3
Press the t/s buttons to move the cursor (-) to ">>>".
4
Press the –/+ buttons to start searching.
The – button searches for lower-numbered channels;
the + button for higher- numbered channels.
Repeat this process until you can get the desired chan-
nel.
5
When the desired programme is shown, press the t/s
buttons to move the cursor (-) to "
6
Press the + button to memorize the channel at the cur-
rent postion.
7
When you desire to store another channel at another
postion, move the cursor (-) to "POSITION" with the
t/s buttons and select a desired position with the –/+
buttons.
Then, press the t/s buttons to move the cursor (-)
to ">>>" and repeat the steps 4 to 7.
)/up
".