SMC Networks D-M9 J Series Operation Manual page 8

•Do not use the product in an environment that is exposed to temperature cycle.
Heat cycles other than ordinary changes in temperature can adversely affect the inside of the product.
•Do not expose the product to direct sunlight.
If using in a location directly exposed to sunlight, shade the product from the sunlight. Otherwise failure or
malfunction can result.
•Keep within the specified ambient temperature range.
Otherwise malfunction can result.
•Do not operate close to a heat source, or in a location exposed to radiant heat.
Otherwise malfunction can result.
Adjustment and Operation
•Adjust the Auto switch in the middle of the operating range and then fix it.
Adjust the position of the Auto switch so that the piston stops in the middle of the operating area (where Auto switch
is in ON status).
Mounting the Auto switch close to the edge of the operating range can cause operation to be unstable.
•Turn the power on after connecting a load.
If switched on with no load, excess current may flow, causing the product to break instantly.
Maintenance
•Turn off the power supply, stop the supplied air, exhaust the residual pressure and verify the release of
air before performing maintenance.
There is a risk of unexpected malfunction.
•Perform regular maintenance and inspections.
There is a risk of unexpected malfunction.
•Do not touch the terminals while the power is on.
Otherwise malfunction and damage to the product can result.
•Do not use solvents such as benzene, thinner etc. to clean the Auto switch.
They could damage the surface of the body and erase the markings on the body.
Use a soft cloth to remove stains.
For heavy stains, use a cloth soaked with diluted neutral detergent and fully squeezed, then wipe up the stains
again with a dry cloth.
Other
•Contact SMC for information regarding water resistance, lead wire bend resistance.
•Contact SMC if there is a problem with the product's ON/OFF positions (hysteresis).
Hysteresis
•The resin housing can be discolored due to the operating environment.
Due to the characteristics of the material used, the resin housing can be discolored by sunlight, but there is no
effect in strength and other characteristics.
-7-
No.D-※S-OMS0002-B