Table of Contents
Advertisement
for any damages that will arise when the
product is used without grounding in
accordance with the local regulations.
regulations.
reach after installation.
breaker protection are specified in
the "Technical specifications" section.
If the current value of the fuse or
to your mains voltage.
extension cables or multi-plugs.
Damaged power cables must be
replaced by the Authorised Service
Agents.
Electrical requirements
Before you insert the plug into the wall
socket make sure that the voltage and
the frequency shown in the rating label
corresponds to your electricity supply.
We recommend that this appliance be
connected to the mains supply via a
suitable switched and fused socket in a
readily accessible position.
Should the mains lead of the appliance
become damaged or need replacing at
any time, it must be replaced by a special
purpose made mains lead which can only
This appliance must be earthed
If the fitted moulded plug is not suitable
for your socket, then the plug should be
cut off and an appropriate plug fitted.
Destroy the old plug, which is cut off as
a plug with a bared cord could cause a
shock hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this appliance
used. Do not forget to refit the fuse cover.
In the event of losing the fuse cover, the
plug must not be used until a replacement
fuse cover has been fitted. Colour of the
replacement fuse cover must be the same
colour as that visible on the pin face of the
plug. Fuse covers are available from any
good electrical store.
Important
Fitting a different plug
lead of this appliance may not correspond
with the coloured markings identifying
the terminals on your plug, proceed as
follows:
(earth) wire to the terminal in the plug
marked 'E' or with the symbol f or
coloured green and yellow or green.
2
Connect the blue (neutral) wire to the
terminal in the plug marked 'N' or
coloured black.
3
Connect the brown (live) wire to the
terminal in the plug marked 'L' or
coloured red.
be fitted either in the plug or adaptor or in the
main fuse box. If in doubt contact a qualified
electrician.
EN
Advertisement
Table of Contents
