TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig° 29)
°
Block up axle securely_
o
Remove axle cover, retaining ring and washersto ailow
wheel removal.
°
Repair tire and reassemble.
o
Replace washers and snap retaining ring securely in
axle groove.
•
Replace axle cover.
WASHERS
RETAINING
AXLE
COVER
FIG. 29
"POSITIVE"
(+)
"NEGATIVE"
[-)
L.H.
PANEL
BOLT
FIG. 30
REAR WHEEL -
,,
Block rear axle securely.
°
Remove five (5) hub bolts to allow wheel removal.
°
Repair tire and reassemble. Replace and tighten hub
bolts securely.
TO START
ENGINE
WITH A WEAK
BATTERY
(See Fig. 30)
CAUTION:
Lead-acid batteries gener_...........
t
ateexplosive gases. Keepsparks, flame
and smoking materials away from bat-
I
teries.
Always wear eye protection
|
when around batteries.
II
if your battery is too weak to start the engine, it should be
recharged°
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: YOUR TRACTOR tS EQUIPPED WiTH A 12
VOLT NEGATIVE GROUNDED SYSTEM
THE OTHER
VEHICLE
MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES
TO ATTACH JUMPER CABLES -
°
Connect each end of the RED cable to the POSITIVE
(+) terminal of each battery, taking care not to short
against chassis,.
•
Connect one end of the BLACK cable to the NEGA-
TIVE (_) terminal of fully charged battery,
°
Connect the other end of the BLACK cable to a panel
bolt on the left side of the tractor, away from fuel tank
and battery
TO REMOVE CABLES, REVERSE ORDER -
°
BLACK cable first from chassis and fully charged
battery.
,
RED cable last from both batteries,.
TO REPLACE
HEADLIGHT
BULB
°
Raise hoo&
°
Pul! bulb holder out of the hole in the backside of the
grill.
°
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
•
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
°
Checkwiring_ See electrical wiring diagram in Repair
Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse, The
fuse holder is located behind the dash.
23