Tip 6: Using Lists - Texas Instruments TI-83 Plus Software Manual

_ Try-It!Ë on Your TI83 Plus
Set Up the List Editor
Use the commands
To Do This
1. Display the list editor.
Note: Your list editor may vary. The following
commands will clear and set up lists L1 through L6
in your list editor.
2. Return to the Home screen and clear
it. Then clear all lists in the list editor
by selecting
ClearAllLists
Note: This command clears all elements from the
lists. The list names are still in memory, but the
lists are empty.
Hint: In the CATALOG, you can go to the first item
q
starting with a particular letter:
Press C ( ). Notice that you are already in
ALPHA mode since the
right corner.
3. Setup the list editor with
g
Hint: You also can select SetUpEditor by pressing
5.
4. Display the list editor.
Note: Lists L through L
1
and there is a blank list following L
Fundamental Topics in Science
and
ClearAllLists SetUpEditor
.
º
displays in the upper
SetUpEditor
appear and are clear,
6
.
6
© 2001 Texas Instruments
to reset the list editor.
g
Press
1:Edit
- l :
- |
#
until is
ClrAllLIsts
selected
b
b
- |
.
#
until you highlight
SetUpEditor
b
b
g
1:Edit
_

TIp 6: Using Lists

Display
_ TIp 6-2