How To Switch To Plate Condensation Mode Immediately After Cooking - Hitachi RZ-W100CYH Operating Instructions Manual

How to switch to Plate Condensation Reduction mode immediately after cooking
●
Condensation collects on the inner lid and other plate immediately after cooking is completed in order to keep the surface of the rice from drying. If
you are concerned about condensation, you can switch to Plate Condensation Reduction mode in which the length of steaming time is increased.
Once the mode is switched, the setting is remembered until you switch it back to the original mode.
1
1
Insert the power plug into a
power outlet
2
Press
seconds to switch to a mode in
which to change settings.
3
Press or
the display.
●
The display will be switched each time you press
●
Press to move to the next setting. Press
move back to the previous setting.
4
Press
●
Press to change the "Plate Condensation
Reduction mode" setting.
5
Press or
settings.
●
The display changes each time you press
or .
6
Press
settings.
●
Pressing
screen returns to the initial display.
3 5 2 4 6
for approximately five
to show "P3-" on
or
.
to switch the
to confirm your
enters your settings and the
Lights up
(Setting the melody (Setting the
of an alarm) LCD display)
P.E-16 P.E-15
.
to
Lights up
Regular mode
●
Pressing the "Cancel/off"
button enables you to return to
the initial view even during
setup. Any settings you have
not confirmed will be reset.
(Setting Plate Condensation (If you are concerned
Reduction mode) about odors)
P.E-34
When switching to Plate
Condensation Reduction mode
●
Approximately five more minutes
of cooking time will be required.
●
The amount of water droplets that
collect in the plate will reduce.
●
The rice cooker uses high pressure and
thus it has a tight seal, so there will be
some condensation even after switching
to Plate Condensation Reduction mode.
Select "Warm-High" if you are
concerned about condensation
during Keep Warm.
Plate
Condensation
Reduction mode
●
If no operation is performed for
approximately three minutes,
your setting is automatically
accepted.
P.E-28
E-17